is this condensate pipe connected correctly?
will the water flow away?
the pipe runs slightly down hill when it goes through the cuboard before going up to the boiler the entry on the right is the washer waste.
any one know where i can get 22mm pipe clips like these.
ive got a few on the gas pipe that are broke and i need some that dont have the screw behind the pipe
im just gonna replace a toilet syphon but not sure what size i need , ive got a 9.5 inch syphon but not sure where that measurement is taken from. i might replace it with a dudley 88 turbo ive read that they are measured to the spillover height. so if i measure my water level height and say its...
Im gonna hang some 1400 grade lining paper and then paint over it, read that its best to size the wall first. Do i mix the paste as it aays on the pack and do you have to let it drry before hanging the paper or can i hang when its still wet. Also do i try and butt the paper or leave a small gap...
Just got afew small patches of plastering repairs to do onto bare brick, was going to do the backing with sand and cement, do i use building sand and what would be the best ratio to use and do i need to add any additives ?. Thanks
going to replace a 960 wide rad with a 900 , i was going to use 2 telescopic tail extenders but read quite a few people had prblems with them leaking, then i came across this idea on another forum wich sounds ideal for what i want to do .
Just get straight 15mm chrome compression couplings...
i need to replace a radiator that measures 96 x 59 cm , but i cant seem to find one the same size they seem to be 90 or 100 cm. the pipework is set in the plaster on the wall so i dont really want to try and adjust it.
just been fitting a new ballcock diaphragm in the loo, and was quite sure if i put it in the right way round, is it the side that pushes out easier that goes towards the cone thingy ?
hi just a quick question, what cable do i use to connect a electric hob to the cooker point , the cooker point is on its own circuit using 6.00mm cable. Do i just use 6.00mm twin and earth to connect the hob to the cooker point. or do i use a thicker flex cable ?
i want to fit a piece of kithen worktop that has a wall at either end that are out of square , any idea how i can scribe both ends so that it fits snugly against both walls, hope this makes sense.