Recent content by Wokman

Agree, but we plan to put a dinning table in front of it, and the last thing we want would be guests to back onto a hot radiator. Gives a differnt meaning to a Sunday Roast :)

Here is a picture. Not sure of the make.. It says 'British Gas' on top. [/img]

Do I need to get a plumber to do this one?What effort is need for this? [/url]

Hi, We have a rather unsightly radiator which i am hoping to cover with a radiator cabinet. However, the radiator has a TRV valve. I remember someone in BG telling me that we cant put a radiator cabinet on a radiator with TRV valves, since the TRV will cut off supply as the radiator heats...

We had a new Combi heating system put in by British Gas. The boiler is a Worchester Bosch. They put in an 15mm Aquadial ceramic Scale Reducer. We havent had much issue with the system (other than dealing with BG itself !!) My Question is does the Aquadial ceramic Scale Reducer need...

I am planning to put a Bosch Tumble Dryer into a utility space that I have created on the 1st floor. It is directly above a of a newly created pillar that will hold one end of an RSJ (which is being put instead of a load bearing wall). I am a bit concerned about the viberations that the...

Thanks for this....Will take the advise and move to lower Online tariff rather than go down the E7 route. Have a nice Easter

While I was looking for pre-engraved.. this sounds like a good idea.. any idea of where to get these.. also any view on the costs?

We recently moved into a new property which has had a new boiler A grade Worcester’s Greenstar gas boiler put in last year along with new radiators/thermostats. All the appliances we have are A star including a large American Fridge Freeze. We do our washing during the week (an A grade Bosch...

Hi, I am planning to put a grid switch panel in our kitchen with switches to control to undershelf light, insinkerator, hob etc. Do you know where i can get grid switches with words like 'Fridge', 'Light' etc on them. I have seen these used in New build apartments, but cannot find them at...

did a couple of wash loads, and it is a thing of beauty even at the 1200 speed. Not much viberation or noise. You guys are life savers. Have a nice Easter

Thanks rocks1 and Leccy758, I took the transit bolts off and put the plastic spacers. Also had a (very) minor levelling done. Ran a dummy (empty) run of the machine, and it works like a proper Bosch should. Bless it. Will do a proper load run of the machine over the weekend and will come...

No.. I loosened the bolts to get the cables free. After that I tightened the bolts back. The installation guide mentioned that I should replace it with the 'covers' and store the transit bolts away. Does this matter? I thought it might be safer to leave the transit bolts on the back rather...