Recent content by XanderHarris

That's hot outlet

I want to swap my kitchen tap and there is no isolation valves in the sink. The hot water is from a mains cylinder will I have to turn the cold of then run the run water off until It gets below the hot outlet on the cylinder?

What size hole cutter is needed for bath tap mixers?

Thanks so you fit the fluidmaster adjustable ones?

Thanks yes looks highly adjustable

Are the fluidmaster 2 part syphons any good?

Im swapping a bath and wanting to add a shower above it. Imagine I need to remove most of the plaster board from that wall to get the pipes up for an exposed mixer or bath shower?

Attach the wall then silicone where the bath with meet it and the wall. Then do you use straight brackets to attach bath to batten?

Thanks does the 50x25mm need to be treated?

What size batten is best to attach to the wall when installing an acrylic bath?

Thanks there is no void at the back of this unit is a strange IKEA one

I have a kitchen unit to first fix, the waste in solvent will enter the unit from the back. The hot and cold will come from below. Is it best to do the waste first, first fix pipes and leave under plinth. Fix unit back. So waste is in unit. Then reach under and bring the hot and hot up from...

Thanks the nut wants cracking abit to turn it square. It's at a bit of an angle so isn't helping matters

Thanks it would be a bigger washer on this sized valve?

It's definitely bigger then half inch