Cause guessing the threads on another iso valve wouldn't accept the nut of a conex iso valve? Yes the house is a very poor set up the gate vale is on to lead do abit of an awkward job
Have a property that has a gate valve for a stop tap so obviously doesn't turn the water off fully. Then a conex iso valve after this. If it starts leaking from the slotted part when turned off I was going to swap it for another, with the water throttled down as much as possible on the gate valve
Thanks. Its not totally like that though I just need 2 45 degree bends pulling on a piece of pipe but need the end of these 45 degree bends to be 400mm apart. Any help?