cross over bend between too points

[jeff the gasman]

Right, let's put this to bed.
400mm spread so cut a piece of tube 420mm, pull 2x45 degree bends and trim slightly to suit, attempt to assemble and bends are at a tangent, cut pipe add coupling job done. Happy days.

 

[Xanderharris1]

But a proper plumber could do it without fittings I guess?

 

[Xanderharris1]

Right, let's put this to bed.
400mm spread so cut a piece of tube 420mm, pull 2x45 degree bends and trim slightly to suit, attempt to assemble and bends are at a tangent, cut pipe add coupling job done. Happy days.

Is that how most plumbers would do it? Thank you

 

[AGAS]

Is that how most plumbers would do it? Thank you

NO , but crack on with advice from jeff