Hi, with my heating / water system I have to have the HW and CH on for my rads to heat up. Is this normal - been asking around and people have said they can get their rads on by just turning their CH on.
My hot water is fine when just the HW is on and the boiler light comes on.
If I switch just the CH on, my rads get warm for 5 minutes and thats about it, nothing more and the boiler light never comes on - not sure if its meant too.
I have a potterton boiler in my kitchen under the work surface and a grundfos pump next to it which has a switch on the left hand side in the middle possition.
My system works fine but not sure if I should have the HW on when I am just wanting CH
I do general DIY and a bit of plumbing, if the pump had to be changed I would call in the experts but as I say my system does work I'm just curious to see if I can have it working more effeicently.
Thanks
My hot water is fine when just the HW is on and the boiler light comes on.
If I switch just the CH on, my rads get warm for 5 minutes and thats about it, nothing more and the boiler light never comes on - not sure if its meant too.
I have a potterton boiler in my kitchen under the work surface and a grundfos pump next to it which has a switch on the left hand side in the middle possition.
My system works fine but not sure if I should have the HW on when I am just wanting CH
I do general DIY and a bit of plumbing, if the pump had to be changed I would call in the experts but as I say my system does work I'm just curious to see if I can have it working more effeicently.
Thanks