Search results

I want to switch a single switch to a single socket. On opening the plate, I found a black and blue wires both connected to a single plastic connector shown in picture. These were both inserted from the same end too. The wires come from different points into the box. Can someone advise which is...

Anyone able to help?

Hi The temperature lever in the attached shower valve has snapped off, the small bit that you can move the temperature dial with. I found a similar part here - https://www.amazon.co.uk/Aqualisa-Shower-Temperature-Control-Assembly/dp/B07V57S5BW. Is it easy to swap this over or will I have to...

I have two of these flat panel electric radiators for which the controls don't seem to be working properly and I have lost the manual. The radiators work at times but I am not able to set them to work continuously (even with thermostat dials at max). Does anyone know how to adjust these or use...

Thanks, the existing transformer is not for LEDs i dont think as these are regular 20w halogen bulbs. Any suggestions what I could swap with? Sorry @Taylortwocities recommended the same one I posted but I am guessing this wont work.

There are two under cabinet lights so likely a single transformer. Is it better to swap with this? https://amzn.eu/d/1nA6zEs

Thanks. Those Knightsbridge ones are sold out. I could get these https://www.tlc-direct.co.uk/Products/KLTWW.html Is it easy to swap the whole unit? I am comfortable working with electrics.

Thanks to you both. Attaching holder picture. I want to try to swap out the bulb and holder bracket ideally. The wire has two small pins that the halogen inserts into. I can get the bulbs but not sure if i can find the right holder/bracket.

Could anyone advise if I can buy just the housing and bulb for this light as it's broken. Thanks

Ok thanks, so no way of doing this without draining the system?

Any suggestions here?

Success! Thanks so much terry and stuckinarut! Repacking the gland worked and I learned a lot along the way. Last question. The other side of the rail has this valve with a screw head (picture attached). There is a very very slow leak here - a drop forms over 3-5 mins. Any suggestions for this...

Cleaned it up!

Ok will try this and get back. Thanks!

It actually does look like a separate nut, I will try cleaning it a bit more tomorrow. How do I get to the packing? I am guessing I could have a go at applying ptfe after unscrewing it?

Thanks, tried elbow grease but not much black stuff coming off. Attaching pictures from different angles.

I have a heat only condensing boiler on the ground floor attached to a water cylinder. It is pressurized and I have been re pressurizing it when the pressure drops. This towel rail is on the first floor bathroom. There is another towel rail in the same bathroom which is physically located lower...

Thank you. Do you suggest swapping the whole unit (chrome part as well) or is it possible to change just the brass valve? Also is it something I can do it would you suggest a plumber.

Please see attached. Also, I put that ptfe there it wasn't there earlier.

To update, I managed to change the bleed valve successfully and it's not leaking anymore. However, now I found that the bottom right still has a tiny leak. Picture attached. I am guessing the valve needs replacing. Could you guide me on replacing / tightening this. Thanks