Search results

  1. C

    micro bore copper

    Have done similar to that,I have done similar to the above.have used duct tape for corrosion protection. Though one downstairs rad is on a studwall I have dropped in 15mm and reduced to 10mm on the elbow as it exits the stud wall. Have done this to give the pipes more stability. Should this be ok?
  2. C

    micro bore copper

    Just so its easier for the plasters to cover. I prefer 15mm too.
  3. C

    micro bore copper

    I understand sadly, not aloud to use plastic.
  4. C

    micro bore copper

    Anyone used micro bore copper to install heating on a new build or domestic house. How did you go about using it for dropping down to the ground floor rads?
  5. C

    notching vertical stub in wall

    Is there a maxium depth you can notch a vertical stud of a stub wall?
  6. C

    Hourly wage for a plumber

    And can gas raise that a lot?
  7. C

    Hourly wage for a plumber

    employee
  8. C

    Hourly wage for a plumber

    Plumber, at the moment
  9. C

    Hourly wage for a plumber

    In the Yorkshire area
  10. C

    Hourly wage for a plumber

    What is the standard hourly wage for a plumber?
  11. C

    Solder runs/ snots on pipe

    Thank was just worried the inside of.the pipe may look like the outside.with the snots thus effecting flow
  12. C

    Solder runs/ snots on pipe

    Just snotted down the pipe . I use a flux brush so try clean it off it runs down the pipe. Can solder run like it does down the outside of the pipe on the inside?
  13. C

    Solder runs/ snots on pipe

    Though unsightly do solder runs/ snots on pipes have any impact? I try and solder quiet neat both on show and on unseen pipe work. My colleague doesnt solder neat on pipework under floors etc and leaves snots
  14. C

    first fixing for basin

    Sorry I mean bringing the pipes up through the floor so the fall just behind the pedestal. I am guessing about 5/6 inch but as yet we have no spec for the basin just that it will be a pedestal basin.
  15. C

    first fixing for basin

    when first fixing the hot and cold for a pedestal basin but u don't have the basin dimensions what distance would u bring the pipes up through the floor?
  16. C

    15mm cold feed

    Sorry just a standard house with a combi boiler. The house has a bathroom and small ensuite. Is a 15mm cold supply enough for this. The incoming supply is 25mm mdpe. Do you need to know pressure etc?
  17. C

    15mm cold feed

    Is a 15 mm cold feed enough for a house run of a combi with a bathroom and.suite. As long as there is enough pressure. Obv. Feed off 25mm mdpe
  18. C

    First fixing a house hot and cold in 15mm

    Thanks I realize the combi may struggle but were I work always fit combis is a price thing I think. Will be a 30kw combi though. Was just worried the one 15mm run feed a shower and bath in separate bathroom maybe an issue? But the whole house is pipes in 15mm. So can't see how teeing of the main...
  19. C

    First fixing a house hot and cold in 15mm

    when first fixing a house off a combi. And the hot and cold pipes are 15mm through out. Is it ok to tee off the main run of hot and cold pipes once to put up 2 bathroom on with a bath and one with a shower. The only other supply's required are to a cloak room basin and toilet. Am I right in...
  20. C

    condensate fitting in wall

    So its ok that you d d never know if was leaking, would glued be better than push fit?
Back
Top