Search results

  1. A

    PVC into Cast Iron

    That looks as though it could be a threaded socket ? if so you can get BSP threaded waste fittings as per this picture.
  2. A

    Right-angled 3/8" BSP screw adapter?

    You can get a 3/8th BSP street elbow that is male x female and will do what you want.
  3. A

    Options for removing surround / gas fireplace

    Calm down....My near 50 years as a gas fitter/plumber entitles me to ask the question or any question i feel like asking.
  4. A

    Options for removing surround / gas fireplace

    Is it a gas tap or a chrome restrictor elbow ?
  5. A

    Low water pressure

    You've probably got some grit in the ballcock..An easy enough job with some grips.
  6. A

    Central Heating Pipe Layout

    Or use manifolds and microbore for a quicker heat build up and less heat loss. Plus more flexible for a DIYer...easier to bend.
  7. A

    New custom bath panel and problem floor vinyl gap

    You need a length of skirting the same colour as the panel or flooring.
  8. A

    What sort of tap fitting is this - and how do I tighten it ?

    Or just a screwdriver.A lot of them threaded bolts are slotted on the end and can be tightened with a screwdriver
  9. A

    Chrome elbow for bath tap

    Show us a pic of the tap thread.If it's just a normal 3/4 tap thread then just buy what i showed above but both ends female and use some ptfe tape to seal it.
  10. A

    Chrome elbow for bath tap

    These are on ebay at £6.29 each..3/4 inch M/F
  11. A

    Stand for cold water tank getting rusty, how can I save it?

    Never mind the rust,who did the pipework and lagging.David Blunket ?
  12. A

    newbie - 15mm plastick pipe Softener inlet (Mains) leak - Help!

    That short piece of grey pipe looks damaged ?
  13. A

    newbie - 15mm plastick pipe Softener inlet (Mains) leak - Help!

    No need to go outside.Just turn the full lever on the left of picture and do as stated above with a piece of copper and two new olives.
  14. A

    Reduce UPVC frame width

    I used an electric planer on mine to take the ribs off.A lot of white powdery dust but done the job.
  15. A

    No fixings

    Run a timber around the inside of the wall and screw through into the worktop from underneath.Pre drill the timber to make it easier to fix worktop.
  16. A

    Permitted Development Rights - Outbuilding joined to House via Conservatory

    Copied and pasted......Where an extension attaches to a pre-existing outbuilding, the pre-existing outbuilding becomes part of the enlarged, improved or altered dwellinghouse; as such the conditions in A.1 (i) apply, i.e. the resulting extension cannot project by more than 4m from the rear wall...
  17. A

    Garden wooden gate leaning from top

    That bottom diagonal brace would have been better going the same way as the top diagonal.
  18. A

    How to fix this dripping tap?

    I have used them many times on that type of cartridge you linked above and they have worked a treat. Type this in the search box on ebay. If they don't fit you have only wasted £3.50. New Valve Tap Replacement Ceramic Disc & Silicon Washer Gasket Insert 1/2'' UK
  19. A

    How to fix this dripping tap?

    This kit on ebay will fit your taps and is less than £4 for hot & cold.
  20. A

    shallow bath waste washer

    Measure the diameter of your bath waste and the washer needs to fit inside the trap but seal against that waste fitting.
Back
Top