Search results

Tricky one as could be anything on the data line. Are there any other keypads, tag readers, zems ? If just the one keypad you want to be checking for 1/4v between 0v and d3/d4. Check cable resistance. If all ok all you can really do is try a new keypad. If other devices on data line then...

It could also be that something else on the network is already using the 113 address. By the way it is of no use to redact your LAN ip addresses as this is only accessible within your network.

Have you actually set the ip address on the camera or are you just putting it in the nvr... does it show up in SADP ?

If you run CMD and type ipconfig on your pc u will beable to see the ip adress of your computer, subnet mask and default gateway. U will need to give the doorbell an ip on this range with the subnet and gateway the same.

Yeh your doorbell is not connected to the NIC of the NVR like the other cameras, this is not accessible from the home network, u need to address it on the LAN, then add it manually on your NVR which is connected to the LAN

There is on the euro panels, check in the 01xx and 02xx range. You can get an output module that connects on the bus line.

There should be different outputs for final set A, final set B etc dont know the numbers off the top of my head

99 tick will exit eng mode

Remove power, reconnect power

If the same PIR that has been moved from the kitchen to the lounge is causing the fault, and the battery os good then you will likely need to replace it. If the pir that was moved from the lounge to the kicthen is causing it then you will need to look at relocating it away from possible causes...

Ive only used the veracity highwires, u will need 1 per cable and they are not the cheapest lol. Haydon worth a try at 20 quid

https://www.google.com/search?ie=UTF-8&client=ms-android-samsung-rvo1&source=android-browser&q=ip+over+coax

There is a seperate volume control for app setting. Set to 0 for silent

Aye they are ****e for that. Not had any issues with the nanos..... yet

Could be a new door....

Its a bit bigger though. Can also use the mcnano-we

Yes

All of them

Make sure input area is set to 'any' for all zones, level set on, and b exit to timed

Take the id biscuits out and fit EOL resistors 2k2/4k7 and obviously wire each detecetor to its own input on the e76 panel