Search results

Thanks - I'll wait for it to dry out a bit more and then tackle it - its still shrinking I like the 6mm pvc idea

Ah ok. Sorry my photos don't really show the roof. It slopes away from that edge. Has a raised lip on 3 edges and a drip edge on the 4th into a gutter. Hopefully that's ok

Sorry I must be missing something Why does it need an overhang? Thanks

Oh lordy now I'm even more worried lol Not sure I can change the roof - whats wrong with it ??

Thanks - I can't get battens on unfortunately due to the roof overhang Would cladding directly on the membrane work ?

That makes me glad I screwed them in :)

Hi all Just built a pressure treated shed - any suggestions for what to protect the wood with to waterproof it ? I don't want paint or varnish or anything that will flake off and it needs to be clear (ish) to retain the natural colour of the wood Something oil based maybe ? deck oil ? And...

So I was very proud of my new shed - for about a week And then I noticed that gaps were opening up between the shiplap presumably as the wood dried out - my bad for not leaving the wood long enough to dry out before fitting I installed it with 1.5mm gap but some of the gaps are now 6mm and...

Thanks Pete - Is that "SWA" I've seen mentioned ? yeah that would be much easier I think - wasn't sure if that had to be buried

Hi Just wondering ifs acceptable to route power to my shed along a standard cable routed in metal conduit fixed to the (very solid) garden wall ? Could be on its own radial from the CU Burying the cable would be a nightmare Thanks

Yeah thats what I'm thinking - but the frame would have to span 2.5 m to get from side to side on the shed - not sure what to make it of ? Too long to use solar rails by themselves - and any wood would need to be reasonably deep Many some lightweight I beam or T beam if thats even a thing

A good question I was planning to build some kind of frame above the roof to increase the angle of the panels. Maybe erdm would be better. This would be better as the slope can be less I think. That part of the project is a bit fuzzy tbh Not keen on mounting them directly on the roof as...

HI all - been a while since I posted Can anyone help re. shed roof construction ? I'm planning a DIY shed 2.4m x 3m pent roof with polycarbonate sheets as covering and am thinking 2x4 roof rafters across the 2.4m span - 40cm spacing - does this make sense or this overkill ? I only ask...

Hi all WB Greenstar 30CDI Fitted in loft Unvented cylinder also in loft The pump on our boiler seems to be continuously running even with water and heat turned off (at programmer) - there's a constant slight vibration from the boiler so I think it must be the pump running - also the temp...

Thanks all - they are victorian solid bricks Will the above suggestions be strong enough to support a person on the roof - I'll need to go up there to do the flashings

Hi - I'm planning a lean to down the side of our house - similar to the below What kind of fixings would be best to secure the horizontal roof support that goes on the house side ? I've always used screws for that kind of thing but would some kind of bolt be better ? Thanks

Thanks :)

Hi We've just moved into a new house - it has an electric towel we need to replace (its rusty and doesn't heat up) but is this location ok ? Its approx 20xcm from the side of the bath - the controls look like they are outside the bathroom Does the replacement need a specific IP rating ? And...

Ok thanks

Hi all One of our radiators is behaving oddly. When it's hot . We can't turn it off with the valve. I.e. turn to 0 and no effect With the valve at 0, If we turn off the heating , let everything cool down and then turn it back on then the rad stays off Any ideas? The thermostatic head is...