Search results

Got the part changed but the vibrating random noise is still there when using hot water / and nkw when heating is on. Does anyone know what’s causing this? The water pressure is good in my area and the boiler pressure is at 1bar...

Thanks Chris. A few months before this issue, I noticed that the boiler would like vibrate for a bit when running hot water. Then after a few seconds it would stop when the tap was opened a lot more. Not sure if the two are linked. Will contact an engineer.

Hi all Started to get a leak from underneath this boiler last few days. The pressure isn’t dropping on the system so assume it’s the inlet that’s leaking. Water is clear-ish as well. I’ve opened it up and taken some pics of the leak below to see where the leak is coming from. Any advice...

Thanks mate. I’ve ordered some wet shield polyurethane from Internet. Will try and use it next week. I did think about resiblock but the cost would have done me. This stuff I got 20L for £60

Hi, been reading numerous posts about sealing block paving. I am heading towards the Poly based seal like Resiblock. My brindle block paving was laid about 5 years ago and is due a jet wash and re-sand but want to seal it this time round. Im after a gloss/wet finish (2 coats?) so any advice...

It seems clean a seems clean around motor?

Every few months, but that said, its the fan fins that i clean and any dirt visible. Been tempted to WD40 the spindle but thought would check on here first...

Thanks. It operates fine for like a few years but then like clogs up. Wired in ok with an isolation switch. The boost switch works too but don’t know if the motors are rubbish on these

Hi, got this extractor fan installed in bathroom. It’s about 3 years old. The 3rd we’ve had since we brought it as every one develops this fault. It has a humidistat which kicks in and operates as normal. But after a few mins it kind of grinds to a halt and then it sounds like it’s struggling to...

Hi, does this mean having a sensor on the front door? can he not just change to timed exit of say 30seconds?

yes it has worked but only if zone 1 ( exit/entry) is not open/active when alarm is set. zone 1 is entry/exit. man is coming over this week to change the mode from entry to timed...

Its over a year old. Everything is hardwired. made sure of this. Not keen on wireless security devices.

Hi, I already had an external gsm dialler so just wanted a way to get notifications via internet of alarm state and control and comip fitted the bill.

ok will wait for the man to come back. no messing apart frm setting up the keypad app to use comip. like i said, it happens occassionally and i think thats the issue with the pir detection.

thanks for the relies. yes was installed professionally. i have access to Wintex as i was given the eng/udp code when we setup comip and had to config the details. No door contact, only pir on exit.

Professionally installed. The installer is away for 3 weeks so thought I’d ask on here to save me waiting...

Hi, I have a Texecom Premier Elite, normal setup with no contact sensors or fobs, just PIRs. So when i activate the alarm and get the message 'Area in exit A', sometimes it stays on this and the tone never stops so assume the alarm never sets. What i think it could be is that when i walk to the...

Thanks John. Understand you now.

Thanks for the response. I’d rather keep the old handles as they are all matching. So would I need to open up the existing lock and replace with the tubular bolt and then would the release knob fit on top where the existing lock hole is?

Hi, I have this lock on the bathroom door but want to change it to a thumb lock (is that what you call it) where there is no actual key, just a turning knob. I don’t suppose there is a way to change it without changing the handle?