Search results

Thanks, this is the engine and it is 16hp. I was going to use a 35ah 12v battery ?

The new ignition is not made for the mower it is a universal one. Normally they have letters, this one does not. Thanks

Thanks, I don't have it it was not on mower when bought.

Hello, I am replacing the key switch ( photo attached) on a ride on mower. I have bought this one which seems good quality but instead of letters by the connectors on the back which I was expecting there are numbers. It is a three position switch OFF, ON and full turn to the right which...

Thanks, I really appreciate all of your advice on this and the video etc. Just one point, did you mean 2.5mm or thicker to starter motor ericmark ? cheers James

Hello, I am installing a new engine into a second hand ride on mower and there are no existing electrics at all at the moment. Can someone tell me what type/gauge wire I need to make all the relevant 12v connections from battery to ignition, to solenoid etc. If it is not to much effort can...

Sorry forgot photos!

Thanks John, I have seen this one on ebay that apparently works well. I am assuming that this particular engine is supposed to be bolted on the way up it is shown here in first photo. Also I notice that the spindle has some sort of collar on it , do you think that could be hard to get off as...

Thanks for your advice , appreciated

Hello, I have bought an old ride on mower (as per photo) with the idea of making it into a mini tractor /ride on for my young son. I have stripped of the cutting deck, heavy brusher/collector and all of the excess weight , redundant brackets , levers etc that altogether came to quite a bit of...

Thanks for your responses. The existing petrol engine revolves at 3000rpm and in operation is left at that permanently. The difference in speed is chosen by which gear is used. The engine power/pulley is disengaged from the gears by a clutch pedal that when pressed loosens the drive belt and...

I need to buy an electric motor to convert a petrol ride on mower to a mini tractor/ride on. The existing engine is 12hp Briggs and Stratton . The mower deck and a lot of excess weight has been removed from the mower and it is much lighter. I have seen an old DC shunt motor 180v 750w 4.9A...

Cheers for your advice and concern Conny. That will be the most important consideration

Thanks, yes of course there would be safety cut of switches. They are already on the mower under the seat etc. These would cut off power if someone became unseated. The vehicle wouldn't go more than about 8 mph anyway.

Thanks all of you for your input, much appreciated. Basically the mower I am going to use has a throttle that is a lever that goes from low to high and stays in the position it is put in. This speeds up, slows down the engine. When the clutch pedal is pressed and gear is selected and then clutch...

Hello, I am converting a petrol ride on mower/grass tractor to electric for my young son. Instead of the throttle that increases speed of the petrol engine I want to install an electric throttle in its place. The throttle needs to be some sort of lever that stays in place at the point it is...

I thought I had replied but it doesn't seem to have logged here !. The ceiling is plasterboard , basically sound but a bit beaten up on the edges. It has been filled in places over many years, I have cleaned/ raked out any loose stuff i.e " back to solid ".

Hi, I have taken a wallpaper covering off a landing ceiling and the surface underneath is in ok condition apart from a few areas. These are mainly cracks or gaps where old filler has come loose and now fallen out. It is going to be freshly plastered over eventually. I have cleaned these cracks...

Thanks all. Transport and siting is not that cheap ! Roughly £400 but no other option I guess. Cheers

Any thoughts ? thanks