Search results

No change mate

You mean every radiator other than the problem one?

Cheers terryplumb but no difference

Not long moved into my house and one radiator refuses to get hot. It’s cold at the bottom and Luke warm at the top. One of the pipes flowing into it is red hot but the pipe on the other side is cold. Both radiator valves look like lock shield valves so could that be the issue or is there a...

Thanks. How’s the effervescence been caused? Maybe not SBR ing the backs?

They do have small pimples on them which have worn which swayed me away from Richmond. They just don’t look grey enough to be Marshalls

Does anybody know what flags these are? I thought they were a basic Marshall’s concrete 50mm flag but they look a lot lighter in colour than the typical concrete light grey ones. I ask because I wanted to use the Marshall’s flags on my driveway but when I’ve seen them at my local landscapers...

thanks Dannyboi2003 that looks as though it will do the job

Thanks Chunkytfg, I did see that when browsing but it’s a bit bulky for what I need.

I’m looking for an outdoor socket that is large enough to accept a transformer plug for a water feature. Unable to locate one so would appreciate advice on this. Thanks

Mains voltage JohnW2

Chivers67 at the moment I’ve ran SWA from CU to the back of the house to an external weatherproof box. I’ve also ran SWA from this box to each point in the garden where the lights are to be fitted. I’ve earthed the armour at the CU end so far. So, to answer your question, I do plan to terminate...

Sorry JohnW2 I meant LED.

I plan to have 4 low voltage garden lights supplied via 1.5mm swa which will be switched from inside the house. I have already ran swa from CU to suitable outdoor box which i will terminate and connect 1.5MM T&E and bring through wall inside house to a switch. I have already earthed the armour...

Cheers. Thanks for the info. Did the blade last for all the cuts?

Did you use a continuous diamond blade? Also, what was the thickness of tile you laid?

Thanks for the reply Mike. I’m also a DIYer and I know what you mean about the mortar usage. You said you used a 5 inch grinder to do the cuts? Was there any splintering along the cut? I’m looking at leaving the all my cuts till the end and the possibly hiring a water fed table saw but they are...

I plan to lay 68msq of Overland Silver Porcelain 20mm and 900x450. Plan to use a brick bond effect when laying. I have prepared the sub base and got all my drainage sorted. My garden is on two levels with steps up to the top level. Ive done quite a lot of research regarding porcelain laying but...

I though about trellis but the Mrs doesn't like it. The posts are 6ft apart.

I would like to replace or revamp my rear garden fence on all sides(3).The existing fence is concrete posts with feather edge panels all around.On one side I need to raise the existing height by about 1 foot, this will bring it to the same height as the other two sides. I like the idea of the...