Search results

ill give this a go thanks

More pics

ok thanks, but what does this mean? I have a multimeter and changed all batteries and still get the menvier security version 4.1 screen on the panel ...any help greatly appreciated

getting 11 from the batteries

away from home will check when i return and post back, thanks

Yes

Yes waited 20 mins, theb powered up

Yes and waited 20 mins

i think there is some other issue, i did a power down and restart, no luck, what i did notice when i pulled the power/wall fuse is the outside bell stopped. and it doesnt seem to be taking power from the batteries even though these are new...keypads are completely grey with no power to...

no all seems ok, i just swapped batteries

the point is the keyboard works when i press the buttons it make the press button tone sound but the screen doesn't move off from what you see. is there a shut down sequence I need to follow? Or what do I need to do to reset?

I have the engineers code..

Hi, Please can some help.... i have an old menvier TS2400 alarm, it showed a battery fault on the keyboard, assuming the one of the batteries died and then the bell went off, waited 20 mins and for it to stop. The next day I replaced the battery in the control panel and there is a secondary...

thanks I have decided to do 1,2,3a for now and when I get the funds do 3b. any suggestions on the type of CU to use? also should i get the mains fuse changed to 100A? thanks

thanks all for the helpful advice :)

yes I hear you!! will get one in, just trying to figure out wether to cancel christmas!!

Any ideas what this may cost?

I agree, maybe it's best to change the lot get a large cu instead of 3 and run new cabling, thanks again

any idea of the cable I will need to run to the CUs? and do i need to get the mains fuse update as it is only 60A??

its not a rental and not sure if there is any benefit