Search results

That is freakin' excellent!

I would have thought if the valve has failed open, disconnecting the electrics plug from the valve would have no effect. You will need to replace the valve or bypass it I think.

I think you can achieve that by joining the two hoses together that come from the engine at the heater valve in the bulkhead - that should bypass the heater matrix inside the car completely.

Just a quick follow up on this. Finally managed to get round to looking at this again. Popped a new plug in and she roared into life in a huge cloud of smoke on the first pull. Many thanks for your assistance.

Hi john, thanks for taking the time to respond. The diaphragm was indeed a genuine one. I don't think it was flooded, certainly not to begin with - I pulled the thing until my arm nearly popped out of its socket! The plug did look a bit sooty and damp, I also thought the gap looked a little...

Flymo Quicksilver 46sd with Briggs and Stratton 450 series 4 stroke engine. A year or two ago the above mower was hunting and puffing black smoke, I replaced the diaphragm under the carb and it was running sweetly. It rested up last winter (nothing drained down), I had a bit of a job getting it...

Is that a piece of T&E connected to the earth clamp (exiting to the right)?

Heh! There's not too many about I know, but no that wasn't mine. :lol:

I've got one of those! :wink:

That looks like two tails & one T&E to me!

Ah! I thought Westie would have the answer. Is it likely to still be in use - it looks like it's still connected?

This LV distribution pole is located in a large residential area where fenced transformers on the ground are the norm, I can see no feeds going up the pole & the street lamp gear is obvious. Anyone got any ideas what the small transformery looking device may be for? (This is the only...

Cheers guys, I'll give it a whirl.

Because the actual trim is broken where the clips attach.

My GF did this to the carpet in a rented flat. I managed to remove it completely using some fine grade wet and dry sandpaper (used dry). Hope this helps!

I just wondered if anyone has used Isopon P40 as an adhesive? I have just bought a Honda Civic & the plastic trim over the arches has some broken clips leaving it looking a bit uneven & scrappy. I bought some dedicated spoiler adhesive, but the cure time is well over 24 hours (I need to...

Update: LNB now replaced - so far, so good. Fingers crossed! Thanks for the advice.

We'll, I popped home this afternoon and typically did not get the dropped signal problem. I measured the voltages at the wall plate anyway - 13.2 & 17.8VDC stable. I also looked into & checked the cable, it is a solid copper centre core. So I am reasonably confident that the cable is not the...

Yes, they are fully screened, I intend to hook a small gauge insulated wire into the centre pole and carefully close the clamp back down.