Search results

What does SOL mean? I have test reports of 5m deep test pits dug in several places as part of development steps.

I already have 45m2 of decking.

I have non-draining land .... I removed 250 mmm off the top and imported topsoil, but it still don't drain. It was a valley infilled in 50's to make a railway sidings ..... closed since 70's I tried drainage crates and french drains, initially fine, then they fill and takes weeks of no rain for...

It’s a plastic sheet (Foamex) that will have 400 light fibres (4 different diameters) fed from an LED light engine. it is to give a ‘starry sky’ effect. The light engine has a revolving ‘twinkle’ wheel, and can move from white to any RGB mix. Programmed ripple effects etc. So no plan or grid...

Agree I will use in a Dremel rather than my battery drill

Found a solution ..... seems you can buy tungsten drills 0.1 to 1.0mm set in 1/8" diam shanks ... and they are cheap enough.

I have ordered Eclipse pin chuck to try. Find out Tuesday.

I got the 9 1/2 on advice in this thread, that the fine adjustment and adjustable mouth. seems to do what I need it to do.

I have 2 hand drills - this type : bought before battery drills arrived

A single large sheet of Foamex (2m x 1.6m) so needs to be a handheld tool

5mm Foamex sheet .... so PVC face and foamed core .... not hard material What is a 'snide Dremel' is that a particular model ?

Task to drill 400 holes. about 100 of them are 0.03" (~0.75mm) and another 100 are 0.04" (~1.0mm) My DeWalt cordless is a bit heavy to use for this task, and will not close down on 1-.0mm or lower. I thought to use a pin chuck .... tried 2 from Amazon, but they simply don't run true (they were...

I got hold of an old Stanley 9-1/2 (1960's era) Base was true, blade needed sharpening & honing, and it now works a treat.

Only issue is after not a huge amount of use the rubber cover on shadow line on/off button has split. Not sure if I can get a spare.

I’m looking for a 2 part male & female locating pins. Have a 32mm panel that is sliding into a recess, and need some form of guide pins, that will locate into receivers. Found these … anybody know of anything better. I suppose if there was a slight taper or chamfer on leading edge of pin it...

Thanks … will help my search

Is this Stanley a Low Angle plane? Anybody have one can tell by picture (on sale locally)

I’ll look for 2nd hand No.70-1/2 thanks

Time to treat myself to a Low Angle block plan. I have seen plenty of new ‘Faithfull 6012’ models around £23 price point, which is pretty cheap are they any good ? or perhaps a RIDER NO. 60 1/2. But more than twice that price. either of these better ? Also see plenty of used Stanley’s 110’s but...

I have IP65 boxes in the roof so could mount boxes above ceiling, but need LEDs that will be hPoy with high level if humidity when Hot Tub in use.