Search results

Ok thanks all. I do want a socket in there and there is enough room for it to fit but if it's too complicated will leave it. So I opened up the 3 gang switch. Hard to get clear pictures but I tried my best. So attached are three pictures. One from the top of the switch, one from the bottom and...

Thanks all! So some more information. The black wire comes from the back of the box and blue wire from the top. Where the black wire comes from, I can definitely see a wire cut off (looks red). The blue wire is definitely by itself. Behind where is switch is located and on the other side of the...

Thanks. So first apologies, I now realise that it's not possible to simply change it into a single socket. But I almost did, I thought the blue was neutral. But then I reversed my steps as it dawned on me that it cannot be if they terminated in the same plastic casing. Hazard averted. But what I...

Should also mention this switch is a spare, the switch itself was not wired in. The wires were both in a single plastic connector.

I want to switch a single switch to a single socket. On opening the plate, I found a black and blue wires both connected to a single plastic connector shown in picture. These were both inserted from the same end too. The wires come from different points into the box. Can someone advise which is...

Anyone able to help?

Hi The temperature lever in the attached shower valve has snapped off, the small bit that you can move the temperature dial with. I found a similar part here - https://www.amazon.co.uk/Aqualisa-Shower-Temperature-Control-Assembly/dp/B07V57S5BW. Is it easy to swap this over or will I have to...

I have two of these flat panel electric radiators for which the controls don't seem to be working properly and I have lost the manual. The radiators work at times but I am not able to set them to work continuously (even with thermostat dials at max). Does anyone know how to adjust these or use...

Thanks, the existing transformer is not for LEDs i dont think as these are regular 20w halogen bulbs. Any suggestions what I could swap with? Sorry @Taylortwocities recommended the same one I posted but I am guessing this wont work.

There are two under cabinet lights so likely a single transformer. Is it better to swap with this? https://amzn.eu/d/1nA6zEs

Thanks. Those Knightsbridge ones are sold out. I could get these https://www.tlc-direct.co.uk/Products/KLTWW.html Is it easy to swap the whole unit? I am comfortable working with electrics.

Thanks to you both. Attaching holder picture. I want to try to swap out the bulb and holder bracket ideally. The wire has two small pins that the halogen inserts into. I can get the bulbs but not sure if i can find the right holder/bracket.

Could anyone advise if I can buy just the housing and bulb for this light as it's broken. Thanks

Ok thanks, so no way of doing this without draining the system?

Any suggestions here?

Success! Thanks so much terry and stuckinarut! Repacking the gland worked and I learned a lot along the way. Last question. The other side of the rail has this valve with a screw head (picture attached). There is a very very slow leak here - a drop forms over 3-5 mins. Any suggestions for this...

Cleaned it up!

Ok will try this and get back. Thanks!

It actually does look like a separate nut, I will try cleaning it a bit more tomorrow. How do I get to the packing? I am guessing I could have a go at applying ptfe after unscrewing it?

Thanks, tried elbow grease but not much black stuff coming off. Attaching pictures from different angles.