Search results

On a plastic base which sits on pavers

Hi all, Got a new Tiger Shed Workshop and I'm really pleased with the quality, however the floor panels butt up against each other and the instructions tell you to put it together via an angled fixing. I've found it raised one side by about 3mm.. Any idea how to fix it ? In hindsight, I...

There are a few sizes needed 25mm, 65mm and some are 40mm

Speed I suppose, also strength.. I only planned on using them in the frame.

Thank you. They actually come in prebuilt panels.. the studs are 44x27mm. They provide nails, but I wanted to screw it all together.

Morning all, I have a Tiger shed coming tomorrow, and I'm planning on using screws instead of nails where appropriated. Would you drill pilot holes? I have these screws...

Quick question which I probably know the answer to to Supply from Garden to shed. Unable to come up through the floor of the shed. I don’t really want to create another joint and add an adaptable box on the exterior.. but also don’t want to just drill a hole and silicone.. But is it best to...

Hi all.. On just thinking the plastic base will just be for air flow, as I already have a flat paved area.. will they need filling with gravel ?

Storage and a workshop.. I will eventually be insulate the walls and roof

I’m building the shed from scratch so wanted to insulate the shed base underneath whilst I have the chance.

Hi all, Building a new shed I’ve got the slabs laid, and I’ve bought some plastic base to raise it off the ground which I’ll screw to the slabs. I’m going to insulate the floor underneath with PIR boards, my question is do I need any membrane under the shed ? And can I cap off the open end...

Thats the issue.. the conductors going through the wall are now singles.. I think I'll just run some flex from the new DB

Brilliant thanks John..

Brilliant.. I have a socket currently and was going to replace with an adaptable box.. so maybe no need too now !

I get you.. Just didn't think it good practice.. in my situation the socket would have 6mm in and out..

But with it being terminated in a 13a socket then extended to the shed ?

But you are limited to 13a now?

Terminate the SWA and then the singles inside the SWA would pass through the wall.. and no I refuse to earth and correctly terminate other cable types..

Hi all, I think I'm just being anal... but I have an adaptable box in the garden fed with a 6mm SWA. I'm extending this to the shed, and I want to avoid another joint, but I don't want to terminate outside the shed in the box and just feed singles through the timber wall (12mm, may have...

Hi All, I want to install a water filter for my kitchen sink.. WATER2 or WATERDROP. It currently has a flexi hose with a pushfit to it. What do I need fittings wise to install it ? Do I need to cut the pipe in order to use 2 pushfit threaded adaptors...