Search results

No they are not brass. I tried to tighten it but no luck. I have also just spotted that the others are phillips but the loose one is just the slot type. The floor is Wodden

How is a Toilet fixed to the Floor? This might seem like a silly queston but i was cleaning mine last night and i noticed one of the four screws holding it to the floor is very loose. Are they held in by washers? If so could it have rotted away? I dont see a washer or anything like that on the...

Does anyone know where i can get a small Letterbox Draught Excluder? My Letterbox is small - 21cm X roughly 5.5cm. The ones i have seen are too wide in length. Thanks A :)

What is the Diameter of a Mira Jump Shower Hose? I bought a new one but its too thin for the bracket thing that holds the hose with the Shower head. Thanks :)[/b]

Can you use it on Glass?

I am not sure if this is in the right thread but here goes. I have a Homark Oven not sure of the Model in which the glass in the door of the Oven has become dirty. There are two sperate pains of glass held in by a wire frame and screws. There is a sort of brown gunge on it Does...

The Cold Water Bath Tap had been making a annoying popping noise when you run it and are in the Bath. I thought it might be just needing a new Washer. When i took the Tap apart that was the case but there is also some water that does not seem to drain away from the Tap. I have manged to...

I want just a simple Security Light with a PIR Sensor. It will be going from the outside into the Kitchen with a Plug on the end. I cant afford to get a Electrician in to wire it into the mains.

I am looking for a good Budget Security Light for the back of my House. Does anyone have any suggestions? Also are the LED Security Lights any Good and whats the best Cable to use for Lights. Ta J.D. :)

Yes, i can wire a plug. :roll: Here is a Picture of the Light.

I have a IQ Group E-660 300w Premier Security Floodlight but have lost the manual. Its the one that has no fixing bracket just the holes and wires when you lift up the PIR Sensor. I was planning to just wire it to a plug and not into the mains. So i am unsure about how i would wire it up...