Search results

I wnet through the LEd issue when i was at Orisec and was sat in a room looking at several different bells with there leds on, they are clear and perfectly adequate to be seen in daylight. WRT to the tamper making it brighter that because effectively more current is being run through one LED.

Alas modern tech are sensitive soles

The logs the fault shows up and restores duration 40 seconds. A battery test is 10 seconds long but doesn’t show in the log, but occurs every 24 hours, the times are close enough to consider it’s something happening after x hours roughly 24+. The fault could be caused by power dipping below...

Yeah have them as standard they do a nice little kit with several filters and earth choke. When installing the checks are done and installed. It was a take over and the original PSU wasn’t monitored originally. When it was replaced with a mointored PSU within a week it picked up issues with...

Aware if a few that use this, it can track if they go off wondering, it can be used to talk to them. A family member uses one, it’s with them wherever they go and literally asks if your okay and if you need help if you don’t answer it calls it for you anyway

it makes a call if you don’t cancel it after an incident.

Smart watch?

didnt see frequency on this device, I know spikes and frequency changes can cause PSU's some issues.

I am aware there has been issue to this building in the past, which have been sorted allegedly, I have dug deeper remotely and now have a chain of events leading up to this problems which is almost certainly the start of the chain reaction, just hasn't recovered like the rest of the system, so...

okay this gives me some ideas I can look into

okay money no object whats the cheapest way of doing this buying or hiring. seen somethings on line that arent mega expensive but not sure how good they will be and how good I need them to be, to be fair

hmm thanks.

I am not a sparky. However I suspect an electrical issue maybe occurring in a supply to an out building where part of an alarm system is housed. It’s only the part in this out building that’s affected. It could be the switch mode power supply doesn’t like the feed comming in and it’s being...

I have no idea, have you tried reaching out to Eaton/ Scantronic? But you probably need an R&D bod rather than a tech support agent.

Same as the strobe is okay too, I know you prefer the Xeon tubes, can get a nasty shock off them.

There is nothing wrong with it though?? I guess the question is should it be the same brightness or not by design, how much of it is down to how it’s being viewed I can test it to some degree in if it looks the same or not.

deffo looks normal, But on this device I can see the brightness you claim to be seeing. But this is the correct operation.

Hmm looks slightly different on this device in terms of brightness but looks normal to me

i believe is the video

That’s assuming that’s I have the right video, you could post the link here to see what others think and I can check I had the right video