Search results

I have that screwfix 43131 on my list but couldnt see the rear of it

Its just for a light. Its 20A The light switch is outside the toilet. People use the toilet & walk away. As its gets dark the neon then basically tells somebody that the toilet light is on, thats all Its on /off like a normal light switch BUT the neon is there just for visual to remind light...

I have a on / off switch with Neon on my wall outside the bathroom. Neon is there to remind people light is on etc in the bathroom. The Neon has now stopped working so i need to replace it. i would have bought it at Toolstation or Screwfix so looking at their web page there i see various types...

Confused. I didnt use throttle lever at all only choke when starting You mentioned full throttle then next reply said no or it defeats the object. So when you using full throttle that you mention

So i read you reply wrong. When you wrote **I don't know what your technique is, but always use full throttle, hot or cold.** You mean when the saw IS IN USE

So reading your reply above i might have found the issue with the starting. When i start the saw i move the black lever to the bottom position. I pull it over until it tries to start. Once i hear it try to start then i move the black lever to the upper position shown. I pull it over until it...

10 pulls but nothing in the way of you thinking it will start. Added a drop of carb cleaner down air filter port, choke on then 2nd pull it wanted to start. Choke off then 2nd pull it started & kept running. Ive left it running now 5 minutes & seems ok. So if coil or plug was an issue i assume...

Ive taken mine apart again & i now do see the holes BUT they are not threaded, So never a jet fitted just a hole & it looks like either a small brass fitting with a hole or just a blank at the bottom. Ive taken carb apart again & cleaned it but pretty much clean. I took the chain side cover off...

Just looking at a video and see H and L on his also but they must be blanked off. Now need to go check mine again.

Just noticed H and L holes which mine don’t have

Here’s the carb Ive ordered & looks the same as mine Is the tick over screw your mention the one arrowed.

Well then they are all stupid.

Ha ha I’m not stupid. Two stroke oil & fuel.

From memory I didn’t see any mixture screws. No L or H Diaphragms there was only 1 & it was fine. Carb cleaner through all the holes / ports. I’ve ordered another carb & plug

Carb linkage is free & not jamed. Carb apart & was cleaned but doesnt mean its 100%

Petrol & oil mix. Plug seems ok but maybe dry

When i removed the carb i unscrewed the fuel cap then blew down the pipe & could hear it in the tank so i would say no its fine

I started the saw yesterday & let it run a while & all was fine. Today I went to the job just down the rd but it was a pig to start. Once started operating the trigger didn’t give me much hope with what I could hear. It then sounded fine & I started to cut some logs but after say 5 minutes I...

British gas came out. He changed the stat & receiver for the newer type which is touch screen. Paired in minutes. Boiler fired up but after 10 seconds etc started to die down. Did all his checks etc & then connected a hose to a spout & then into the bucket. There was no water moving...

I press the bottom right button on the receiver & it lights up green then pretty much straight after i hear the boiler start to hum etc. This now has been humming for a few minutes but the green light that should be lit by the flame logo on the boiler never lights up. The green light on the...