Search results

Theirs is no difference whether it’s powered by battery or mains ….unless there is something else connected to,that mains supply ..that only runs off 240 volts …

You have no idea what you are doing !

It’s allready on the network via an app ….say no more …

That type has a rechargeable lithium battery

They never last 10 years …..

Does the faulty pir light up ?

FFS …Smoke alarms bleep when the back up battery is getting low …..for weeks even months ….i think someone would notice …anyway if you fit the AICO smokes all you need to do is release the faulty one and slide in a new unit …no need to isolate anything

If you cant sort out the network side then I wouldn’t bother , you can pick up a 5mp waterproof camera for around £20 and probably a cheap dvr for around £100..

But the picture quality is going to be shhhhiiiiiitttttteee

Yes

Ok ….run both sliders up and down , then reset to correct setting and re try , hold two devices side by side ….. see if any thing is different it’s been know for Texecom to miss something off ….lol

Can log into my dvr via safari ok

Try taking off the jumpers and check for good contact ( no bent pins )

This is what I would do ….download an app like Fing or network scanner ….check what’s on your network , it should give a list of all,devices ….make note ….now connect camera , hold in reset and power up ( this will probably default ip settings and it should pick up new ip address…give it 5 mins...

It’s not that camera ….

Read the spec sheet I posted …it does support a memory card …you would have to connect that camera to the your network to access the card and set it up …that bnc video output is only probably to assist setting up the camera

This may a long shot ….as you are using SIA format …does it transmit text description to the ARC ? if so are there any non SIA text in any of the descriptors , I’ve had with panels if you put say a / in , it locks up the communications ( dual com ) …

I take you don’t get out much ….seen loads of these fittings around the uk ..

I think ( as I don’t really do wireless on the texecom ) you go to device and press “ reset reset “ to delete it ( off top of my head )

Onto keypad and check zones are all the descriptors back in the panel , exit engineer and check that your original codes are in …