Search results

Are the dishes in the top dirty and bottom clean? or vice versa? There is a hose between the dishwasher sump and the metering tank that gets clogged up, if it's clogged it could account for a lower water level.

Problem isn't with the dispenser. Check the spray arms for blockages, especially at the ends as it these that wash the tablet out of the drawer. Also check that the water level in the dishwasher is correct. Partial blockage of the metering tank to sump transfer hose can result in a lower water...

The dispenser top is partially blocked internally and it's forcing water to the front holes, this in turn is getting out under the dispenser drawer, running along the inside lip and exiting under the control panel. Either a new dispenser, turn down the water pressure coming in or you could try...

Sorry, kept forgetting about this one. You need new hinge blocks, this is the part that your hinges slot into. Yours are bent or damaged and are allowing play in the door. Part number from MFI Extracare is OHINGECS, and you'll need two off SD1 Hinge Blocks.

Its a 2 wire plug on the bottom right of the metering tank. To tighten the plug connection, squeeze it gently with a pair of pliers, taking care not to crush it. Clean the edge of the pcb with an eraser.

Nope. Short of changing the metering tank and / or main pcb. The fault lies with the flowmeter connection, if it's not been cleaned and the plug tightened then it won't work. Worked on these for 3 years and never had one where I had to change the metering tank or pcb to cure this fault.

OK. Machine was made around July 2006 so no warranty without a receipt. 7 flashes indicates a flow meter failure. You need to take the machine out to repair it. Take the left hand side panel off, facing the metering tank, bottom right, disconnect the two wire plug from the flowmeter, clean...

There are two 12 digit numbers on a label on the right hand side of the door. Post these numbers here. The start light will be flashing a code, count the flashes and post the number here.

Yeah, I know, that's why I said to keep a note of the model number I've given you.

Part appears to have been superseded from the original. Bosch part number now is 270323. Don't know your model number but it should be the same as the Bosch HME8550GB/01 or the Siemens HF73220GB/02 Keep a note of the model number.

Hiya, depends on the model. As you can't find this (try in the fridge, remove the middle drawer and the label is on the right hand wall) I'll assume it's the Italian made machine. The wheels are a permanent fixture and if it's on a level floor it should just pull out from it's present location...

No model or serial number but it sounds like your machine may be fitted with an Askol wash pump which has gone faulty. Other possibility is a flooded base.

No fuse inside the dishwasher. Not sure what you mean about the on/off switch. Have you metered it to make sure it's working?

Was the replacement identical to the original? There has been a supersession to the original and the wiring on the replacement is reversed.

The carbons are broken. You need to replace them.

Different model. The creda doesn't have the relay.

http://www.diynot.com/forums/viewtopic.php?t=146204&sid=495053ef4047b15383db0e3d961efbcb Not the filters that need cleaning, it's the pressure switch.

Teka is a Turkish company.

Its a waste disposal unit. Sorry, can't read the model number on the pictures.

You just emptied the tub. The base is under the tub. You need to check for a flooded BASE or a leak.