Search results

Safety stat tripping.

Throw it away. You don't need another. They're transit packing. When the long bolts were taken out when it was delivered, these tubes fell out to the base.

Float switch stuck would be the 1st place to check.

Why are you shouting? We're not deaf. :P Anyways, check the carbon brushes in your motor. If they're worn down you need to replace them.

What model?

Prima LPR600 isn't Bosch it's a Whirlpool. Don't know about the 450. Would require all the details from the rating plate to try and work out manufacturer.

You should have received a rewiring sheet with the FHP. You should be able to turn the existing plug through 180 deg and plug it into the FHP motor. (A bit of force as the keyways don't line up). Remember to check which pins are used on the FHP. Use a red marker pen to mark the top of the plug...

If it's a Ceset motor you can order the pump on it's own. Down side is, it's the same price as the motor and pump complete. If it's an Askol, you can't buy any parts for it, it's replaced with a Ceset.

First off, before going into the fhp wiring, what is wrong with the original motor?

As to how it works, part of the heater box is the alternating valve, it's an electrically controlled motor. bottom basket 60 sec. / top basket 55 sec., changeover lasts approx. 5 sec

There's an alternating valve which is part of the heater box. It alternates water every 5 seconds or so between top and bottom spray arms.

If this model has the "blue tubes" inside the sump bowl area then you need to get underneath this and clean out the "horseshoe" pipe.

Now you know why you were quoted for a new facia. The plastic lugs will in all probability snap when you try to remove the facia. Have a good look at the facia and you'll see how it snaps into place.

Check out the hotpoint website. Here's the copy and paste from there. Our fully trained Hotpoint engineers can fix your appliance for a one off repair charge that includes: Call out All parts All labour Repair charges from as little as £89.98 including VAT Our...

Phone them. Fixed price repairs including parts. Upto 5 years old is around £80 - £90. Upto 10 is around £100 to £110.

Service? What model is your Servis? Different models have different wiring diagrams.

Trying to dry a full load instead of half the load. Condenser partially blocked. Not taking in cold water to condense the steam. Any of the above can cause your problem.

Nothing wrong with the element if it's hot at the end of the cycle.

Communication failure. Front and rear boards not communication. Normally failure of the front board.

Expensive repair. You need new electronics. Rear board for the clicking etc. Front board for the "CF" fault.