Search results

You have to hold the learn button on those whilst you insert the battery

So you’ve done no programming? By default all 8 wired zones are unused so you need to go to change inputs and change each detector to your desired mode I.e final exit, entry/exit, intruder also the picture you’re posting is from the wired I/O board on an enforcer not the euro panel.

How have they been programmed in change inputs? picture of the wiring in the sensors would help too is it an enforcer you’ve wired to or a euro panel?

As sparkymarka stated it’s a PSTN board connected to a phone line not a gprs sim unit. Can you see the SIM card on your pictures? PSTN Modem (Digi-1200) This modem connects directly to the telephone line and can be used to send signals to an Alarm Receiving Centre. It can also be used to send...

Rip the lugs off the batteries that you have then you have spares.

Put in your user code - active faults will scroll telling you the problem

Enforcer, wireless capabilities out of the box and 2 wired zones onboard with the wired bell outputs. Comes with Wi-fi card for communication purposes.

Put in your code and when it says 5 problems press 1 it will display the first fault if it says inactive then that fault has been restored and just needs the tick to acknowledge but if it’s still active then the fault needs rectifying

Engineer utilities > Adjust volumes

Go to Alarm Response, change your night set to start at keypad and stop at [1] internal sounder

Engineer code Open panel Down power battery and mains Swap sim (plastic holder slides down and out) Restore power mains and battery.

What communication device is fitted?

De roll the siren, Tamper switch will still activate on the external siren once front lid is removed. Just unplug the battery

Double check connections of the battery.

New battery

Follow this LINK and view the document in your browser it gives troubleshooting for Wi-fi setup and other bits

You need access to the engineer menu, then to communications , ARC/SMS Programming and disable. If 1111 doesn’t work then the installer would have changed it.

Link the temper circuit out in the panel

This keypad will work with your system

Comes with its own backplate which is smaller than that of the 9930 keypad And yes disconnect old keypad and reconnect the same labelled terminals on the new keypad