Search results

As T&GV boards already purchased..need to find a solution. I'll look at some of the links. I only need to do board ends ...and have a Trend T7 and Router table so just need to try and find suitable cutter.

Underway on a T&G ceiling cladding on 25mm wood. The wood has a V profile, (as per sketch) I could have clad in just straight runs .. but chose to have a bit more 'show' about it. Due to layout there are corner sections at 45 degree and horizontal runs to but against them. Sketch (rough) of...

Not sure what tangential direction implies, does that mean cup ‘up’. ?

I am cladding horizontal ceiling with t&g softwood. it has v-profile on both sides, so can be fitted either way up. The board will want to cup in the direction of downwards facing growth rings, so is it best to fit with growth rings upwards so edges pull tighter against the next board, or...

I can't get 100mm wide clear treated locally, so it will be 125x25 ptgv. clear treated. Looking at one source on fixing it states to "Leave a gap of approximately 2mm between each of the subsequent boards to allow for possible expansion." Is this considered best practice ? ... On a separate...

Yes, didn't mention that, but that is my plan I have bought in some PSE ready for this.

I have bought stainless nails ,, so that is sorted. Not sure what the timber will be, other than profile & its Redwood clear treated ..... or even if I can get a choice, I'll ask ....

Guys ..... related Q ...... is there any benefit to using 100 mm wide (95 finished) compared to 125 wide (119 finished) I thought first off using 125 wide would be a better choice ..... It's being run as panels 2 are 750mm wide and 2 are 1.08 wide ..... all are about 3.5m long There are no...

Thnx .... this is an open-sided 'roof' over a hot tub ,,,, situated on a raised deck. I accept your comments .. and maybe 100mm maybe better option.

I have a job to clad an outdoor ceiling with T&G - PTG&V, I posted a Q yesterday on what nails to fix with - a separate Q arose when I came to order. I can get clear treated in 125 width (119 finished) or 100 width (95 finished) Is there any benefit to using 100 mm wide, compared to 125 wide...

Ta

In horizontal … or secret nailed ?

I can easily put the glue in place, Would 2 brads in horizontal surface be better …. Was just thinking about ‘secret nailing’ but don’t have to use it.

Going to be fitting some T&G v-groove profile to a ceiling. I’ll buy the 25mm thick product, so should be about 19mm finished thickness. The ceiling is 400 c/s joists on a timber outbuilding. Will 16G nails from a Finish nailer be OK for the job, thinking 63mm Brad nails .. (stainless if I can...

Need to replace lead flashing over a bay window roof. The roofer used a 2m single length of code 3 … and surprise surprise, it has split. I know it needs to be in no longer than 1.5m lengths and suitable overlap. (150mm?) Is code 4 suitable or does it need to be code 5

This is similar to what I want to achieve … stop folding legs from accidentally collapsing.

No ... on a round bar works fine ... I have a selection of R Clips - but I want to have hole in 2 metal plates further away from edge (for strength)

I'll ask the guy who used them if he bent them or bought like this.

R clips come up as 'R' shaped ..... i.e like this, the clip I added a picture for in OP , is not an 'R shape'

probably not going to bring up the item in a google search ?