Search results

Water service of that age is imperial sounds like 3/4 alkathene If 15mm copper fits it internally its class C if bore is smaller it's class D. If class C just use a short end of 15mm as a insert preferably put a flanoge on one end . You can use 22mm compression fittings on 3/4...

As above or try 2 washers there are brass adapters available much better. The plastic connector is actually 3/4 the tap probably 5/8 they are cheap and cheerful!

We always use braided hi flow hoses much better flow. First thing to check would be to see if there is a filter on inlet hose.

Spanish city Whitney Bay

If you have a multimeter and are competent to work with mains voltage just go through the falt finding sequence in the manual.

Low system pressure? High limit stat? First things to check.

On that basis it's just a sleeve over copper.

Cycling this morning went past this memorial to one of the many ww2 crashed bomber sites in this area. Lancaster 8 crew just 2 miles short of airport 15th April 1945.

That's definitely a 15mm leadlock you can see . Bit more digging out required are you certain that's not a section of 15mm copper blue plastic coated ? (Yes it exists and it's horribly expensive)

As has been noted will require careful detailing but far from impossible. I take it you intend a rosemary type tile? Once flashed a 900mm round chimney that passed through a mansard roof so your proposed porch is a walk in the park!

Take it this Is a basin mixer? Clear picture of connection nuts on new flexi connectors would be useful. The originals look to be maybe 10mm push fit.

I have a very thin & sharp 1 -1/2 in putty knife/scraper just for slicing through silicone sealent .Cheese wire useful as well.

Remove rad and see if it has a warranty sticker on back?

Over the years we have sorted a number of systems extended by 'builders ' Any number of possibilities simple air lock - crap in pipework through poor install - pipework connected to a section of system that's already at full capacity from a heat load point of view. I've even seen...

Your installer may be highly recommended but salamander pumps ain't the best been going downhill for years.. Clear pictures of said install would be useful especially hot connection. What hight is base of tank from pump?

Yes any 18v XR battery will work Sure it's not charger? We have replaced one or two!

As above we have changed a few of them It's on a common backplate so most programmers will fit . We use the eph programmer 5 year warranty as yet zero problems.

On tour of polypipe years ago this fading was explained by the then md Kevin Mcdonald. Brown (and black) have a colorant added to grey polymer to create the colour and it's mainly the colorant attacked by uv. The pipe and guttering fades quicker because that's extruded and the fittings are...

Latest flower in greenhouse orchid cacti For reference flowers over 6in across.

I'm only 40 minutes from Sheffield was a regular at crucible late 70s early 80s. Was at the match where Cliff Thorburn and Terry Griffiths finished at nearly 4 in morning. No I didn't go into work!