Search results

The instructions do not state this, I have a similar picture to what was posted above, but this seems to show the two cables crimped together into a double crimp end which I have never seen before

Aaah that makes more sense now, are those two cables crimped together? I have a single one, is there such a thing as a double one or should they just both be put into the connection

Hi My Bosch Induction hob has come with a 5 core cable, this cable will be connected to the hob as per the instructions but the other end of this will go into an isolator box which means I will have 2 cores spare (grey and black) - where to these connect to at the isolator side?

I'll sort one, looks like the tap will be on the inside of the panel so in theory I just need to be able to bring the feeds through the back to the taps and then the waste

Yeah unit already in, worktop in and sink in. Just need to fit the tap and the waste but the back panel is in the way

The feeds are behind the panel so I need to access them

Hi I am about to install the plumbing for my sink but the unit has a back panel, are these generally removed at installation or is there some fancy cutting needed? I think its 800 wide so I am guessing I could take out a middle section. Just not sure if I should just remove the whole thing Lee

Many thanks

1.5mm

Hi All Been looking at my wiring and have 2 switches in a room, one by each door which I want to be able to turn the lights on and off from at each switch depending on where the room is accessed. I want to understand how to wire these as I have a number of cables. At one switch I have A supply...

Ordered some from Amazon, i bet they turn up now :)

This is the part/s i am after Anyone know where i can get these quick or where they are in the pack?

Its a SMV40C30GB

It is an integrated one yes, looking for the model number now, could it be that these are not needed with integrated?

Hi All I have a new Bosch dishwasher to be installed and i cannot seem to find the part that goes between the dishwasher and the units next to it (to keep it upright i guess) they are like round spacers which fit in between. No idea what they are called or where they are found, it could be that...

Many thanks, i think i will make a hole in the bottom of the cab then out through the plinth at the bottom, hopefully will not be seen. Question though, the hole in the unit is 150 and i have a reducer taking it down to 120mm. What size pipe would i need to go on these? brain is saying 120mm and...

I do have an extractor in the wall to comply. What i need currently is a decent looking output vent I can place on the outside of the island, not too sure whether to go out the side or below it and then out through the plinth piece (150mm). The pipe is 120mm so this is possible, just need some...

Hi Putting together a kitchen and on the island we have a Faber Fabula downdraft extractor fan, one of these things that goes up and down when you are using the hob on the island. Looking at the instructions, I thought I was buying something that did just that, rise up and down and used...

Sorted, there is a middle line :)

I have the guide here and can see the top arrows so I guess that the paper template sits right at the top of the door. Down the sides there are the markings for the holes I need to mark/drill but the paper is slightly smaller than the door so I am not too sure how to position it to get the holes...