Search results

So the SS9 model would be sufficient to heat the space? I also have one of those verticle 1800mm rads going on opposite side of kitchen as well but plumber said these vertical rads are not very good at giving out heat only really design feature?

Kitchen is about 26m2 would the SS9 be sufficient? I am removing a rad and I take it this plinth is easy enough to install?

Hi Has anyone fitted a clock tower on a roof before like in the pictures attached? One pictures show a base made on a roof but how is this attached to the roof tiles? Thanks

Hi My rads are old style single panel ones and have one connection at one end of the rad where I assume the water flows in and out. If I wanted to change the rads to connection ones would I have to convert them to a connection at either end of the new rad or can I keep the single connection at...

Hi acurachris Brilliant thread and you never even laid a block before??? I am fairly good and DIY (bathroom refurbs, tiling and other DIY I will give it a go) only thing I dont touch is electrics really. I am hoping to block up 2 garage doors in the near future, what were the metal strips you...

Have been trying too but thought maybe someone on here wud know

Hi What are the Y axsis for a visibility splay on and 15/20 mph country road in northern ireland? Thanks

Looks good option do they heat better than rads? Is one sufficient in a kitchen?

Yes it will be plumbed to the heating and I have been told it uses very little electric as fan on normal mode turns slowly blowing hot air out.

Hi I have been advised to use a large plinth heater connected to oil heating in my kitchen as I am removing the old rads. Never seen or experienced a plinth heater before are they any good? Do they heat the area well? Better than rads? Thanks

Not sure what thermostat is at but I have renovated other bathrooms before this one in the house and have no problems.

Might be limescale, anyway to reduce this?

Just took the tile off over boarded area where I have isolating valves and low & behold unscrewed the flexi pipe to reveal white stuff clogging the hole. Cleaned the flexi pipe refitted the washers screwed together again and bingo tap running like a tap. What could the white stuff be any ideas?

Hi I have the tap on a sink in a toilet but the water flow has really slowed to nearly no flow at all. I have taken the cartridge out and its seems fine but the water trickles from the tap. Can the tap be the problem or could it be the pipes? I have copper pipes hot/cold running down wall...

Hi I am hoping to knock out the centre of a wall to allow for double sliding doors between a garage and a studio. The roof has no plasterboard or insulation and I can see 2 purlins running the length of roof to the gable wall. In order to knock out the opening I will need roof supports until...

Would it be recommended to replace with oil boiler again or is there a greener way to upgrade the heating?

Hi I am hoping to replace my oil boiler. My current boiler is picture attached and inside a boiler room in house. House is 5 bed, 3 bathroom, 3 reception 3,200 Square ft bungalow but need the option to covert upstairs at a later date. Current system has water cylinder in hotpress (which...

Hi When I put my oil boiler on there is a tapping noise coming from the pipework upstairs. When I switch the pump off the tapping stops but when I switch it back on again the tapping starts again. Anyone knows what this could be? Obviously it is to do with the water being Pumped around the...

No the soil pipe is level with the floor and has the sink waste pipe fed into it. just googled here what about this: Waste Pipe Adaptor - 110mm x 32mm Single To Socket - 13440 (bes.co.uk)??

yeah thats what you had asked for in the loft which is not there. the FloPlast 110mm | Underground Pipe Fittings | Screwfix.com i was thinking of puting on soil pipe in ground and feeding sink waste into it??