Search results

If you really want to do it right, you’ll be wanting to run the grey twin and earth cable in a plastic conduit which will involve removing the cable from where it is clipped to the walls, fitting the conduit and then pulling the twin and earth through it. At the light end of the conduit you...

I am not a Gas Safe Registered fitter. I am a controls engineer, so unless somebody who is gas safe and installed boilers prior to 2018 chimes in, I’m going to say I cannot guarantee this to be correct - However, I’m pretty sure that Part L of the building regulations 2005 also stipulated that...

All of this should be sorted out by your landlord. The heating system is/was not installed to be compliant with regulation. “Time and temperature control is required for all gas and oil boiler installations” “Installers that install boilers which do not abide by the new regulations will be...

Did British Gas install that boiler? We have the same boiler (installed a good many years ago) and when they installed it they did not fit an automatic bypass to the system. For the first few weeks they were back and forwards to our house to clear the same fault but it always came back. All...

No, there’s no real loss in the upstairs system. I get 70 degrees on the infeed to each upstairs radiator. There are only 6 radiators on the one pipe setup.

Hi, I am hoping an experienced plumber or heating engineer can chime in here. Our heating system consists of a condensing boiler (not combi) and the downstairs radiator system is a two pipe system. The upstairs radiators are on a one pipe system. before I continue I just want to say that the...

https://youtube.com/shorts/cfNl3ohk-Iw?feature=share

no it hinges

i did think about replacing it but nothing on the market seems to match the curvature of the bath end at this point. The screen was part of the bathroom suite specifically for this bath. I would be removing it from the wall in order to glue it if I do go down that route.

Hi, the screen was fitted 10+ years ago. There is no plastic hinge on the frame. Nothing has snapped. The glass is inserted into a slot and secured with some kind of sealant / adhesive. If you see the first photo you’ll see what I mean. thanks

Hi, As the title suggests, my son was taking a shower last night and the shower screen glass actually fell out of the metal frame. Luckily he caught it so it didn’t shatter. can anybody advise what type of adhesive I can use the secure it back in the frame? The original stuff seems to have...

Hi, Thanks for the reply. Yes the primer bulb is usually connected to the plastic elbow and air filter housing nicely bolted up with gasket to the carb. I just removed it for the purpose of the video. There is no throttle control or choke no.I shall have a look into cleaning the carb as you...

Hi people, I have acquired a lawnmower from my deceased grandad. It is a Challenge Xtreme XSZ40E with a Chinese Sumec S475 engine. It’s causing me issues when trying to start it and I wonder if anybody has any idea what the issue could be. I have made a small video which I have linked to...

Video

Hi, Does anybody have an incline as to what this means? Came downstairs this morning to find the machine continuously doing this. Nothing mentioned in the manual. Only E xx codes. Thanks.

Just be aware that if you want to extend any conduit runs or make alterations, the thread sizes on the 50’s stuff will be imperial and any new stuff will be metric. You can buy adapters should you need to.

If you can get new cables pulled in - absolutely. Conduit is conduit.

Hi, Basically I need a wiring harness for this machine as the drying thermistor plug failed . It seems you cannot buy a new plug with pigtail and Hoover/Candy only want to sell the complete harness for £180. Anybody got one scrap?

Morning ladies and gents, Wonder if I could pick the brains of some of you appliance knowledgeable people?! Our Hoover WDXCE4852 washer dryer would not heat up. Removed top and found the safety TOC tripped. This safety TOC is a dual unit, with one switch breaking the line and one breaking the...

I will ....but since I haven't bought one yet I'm happy to mess around with this one until the new one comes..