Search results

Hi It looks just like the photos for another machine in a previous post ...but this is mine as well - click on the image to see the larger version... - grey arrows show where the catches are you put your finger in the hole and pull toward the front. As a PP poster said - I find doing one...

Hmmm that is really really rubbish .... This is a replacement for an Ikea tap that was 4 or 5 yrs old. The valves went, were replaced then the handle started spinning on the valve spindle ...and they don't do new handles (and had discontinued that tap) They were very good, it was still under...

It's a monoblock tap and the spout became so stiff that it loosened the tap on the sink. I've managed to tighten up the tap underneath but obviously the spout is going to need to be cleaned and greased otherwise it'll happen again. Problem I have is I can't get it apart. Have found the...

No replies :( Maybe more info would help? I've managed to get the side panel off - found part of the top 'water inlet' full of crap -mainly greasy crud, but had a sliced mushroom in there too... It is in a small reservoir thing around a valve (not attached to any sensors etc but has a...

Thanks I'll ask if he bled it ...would think so but you never know...

Just asking for advice really...is this a coincidence or ? So a (gas safe reg) plumber installed a new hw cylinder attached to a 6 yr old worcester bosch greenstar 30cdi boiler. Just a slightly bigger vented tank. Day after boiler develops a fault...a U9. First on CH only, then on HW. Now...

So started today - did a load and it didn't seem to have cleaned properly (had oven rack shelves in so no top shelf - thought one of the trays had stopped the powder dispenser opening properly) -turned it on again and at the end of the cycle it was making a churning noise but not emptying...

Need to replace the blades on my 2005 Zafira and have discovered 'flat' blades. For £5 or so more than conventional ones I can get retrofit flat ones... are they that much better? Is it worth it? Not too worried about fuel consumption - only do low mileage - more interested in whether they...

That was one of the reasons he wasn't going down the pump path...but another plumber has said he should be fine... :? His flow isn't terrible so tanks should be filling quite fast...(guess if they have a long shower they might get a cold rinse off!) but I'll remind him about that ...

Thanks! So it would be ok temporarily... :) Posted another thread about my dad dithering about how to increase the flow/pressure to shower - wasn't going to have a pump and now another plumber is persuading him a pump might be best ... he is getting such mixed advice! He has decided he...

This might be a stupid question ...(have tried a web search but can't find an answer - so either a really stupid question :D or not wording it correctly ...) If you had a water pump fitted (vented cylinder and header tank) and there was a power cut or the pump failed would the water 'cut...

Thanks - I've got a problem with my internet connection at the moment and can't watch videos until its sorted (its really slow...reminds me of dial up! and it keeps stopping and starting- driving me insane) -but I will when I can... Like I said for an electric shower isn't he is going to have...