Search results

He also accidentally shot a Texas lawyer while hunting. No lasting damage

You could get a piece of tempered glass cut to fit? (They cut it to size then temper it) And paint the underside with the wall paint. It will give you a wipe clean ledge that matches the walls.

Theoretically, yes. But avoid full weight as much as possible. Always rely on woodwork, not plastic to support weight.

I am assuming that you have rafters running front to back? Probably at 10° or more fall for rain to drain? Either start in the middle or go side to side, keep your weight on a ladder. I have stood on poly wall but only where rafters are

Condoms

From memory, it was the top surface. I guess it doesn’t matter but when installing, you need to peel the film off the edge by 25/35mm to clear the joining strips.

10mm should be fine. My conservatory had 10mm when originally built but was changed to thicker after 10 years. If you still have the choice, aluminium joiners are better but plastic is fine, so long as you can live with UV brittle You could use corrugated or even sheet Perspex. The only...

A bit random but…. A wet and dry industrial vac either set to suck/blow from below?

Some better close ups might help? See if there is a makers name. I suspect that they are like a sliding wardrobe door, in that they slide into a top track first, all the way up. Then slide the bottom into the floor track and it drops down? Glass is very heavy. You can buy suckers to help handle...

My American friends often hold a Fourth of July bbq. I used to have a girlfriend in Coventry and mid summer they had some kind of annual celebration based around Godiva. They had fireworks. I get the point. I hate fireworks - there is no need for large bangs these days. There are silent...

If you can’t weigh it down, you could make some posts that are roughly the height of the ramp to the ceiling. Add a small plate of ply/MDF to the top and bottom of the post. This will increase the overall length so that it’s a tight fit and will spread the load. Fit them between the ramp and...

Is it a wooden floor or concrete? You can try to bleach the wood, concrete may be harder. But the Lino will have to come up

Is it dot and dab? Or a timber frame? Look out for noggins

Friends of mine’s parents had a large Edwardian double fronted detached house. Not massive, but with a couple of attic rooms and maybe four first floor bedrooms. Quite a few similar houses were converted to flats or dentist surgeries. They had bell pushes in the ground and first floors. I don’t...

Watch out for the heat gun. It is possible to char the wood and if you are concerned about lead, may well give off fumes. I’d follow the advice above and go with stripper and wire wool

I guess that you could try to find some buttons that match the existing, architectural salvage yard / eBay etc and modify them to trigger a wireless transmitter ? That would save running new cable through the house if you can’t resurrect the old system. Then use the receiver to trigger the one...

Alll I can suggest is lifting some floorboards. The buttons were likely located within range of the bed. But where was that?

Be easier just to build a cavity with insulation all the way up. But add ceiling/floor insulation

If the BT socket area is unused, how large is the USB PSU that is needed? Is it possible to remove the dry lined BT box and enlarge the hole to either accommodate the PSU with a cover or use a larger dry line box? I’d rather not try to run mains up to the screen but is it possible to install...

I have read various posts on this. I have just installed pressure treated vertical feather edge panels in an existing concrete gravel/post situation. The boards are a natural golden colour and I quite like it as is. However I have the time available to give it a water based (?) clear coat of...