Search results

Thanks, that is useful, think it will just use Skype fax then

We have a Redcare line in monitoring our alarm. the phone socket on the redcare box works if you connect a phone to it and you can make calls. But a fax machine wont work even if I use a Microfilter. It just keeps ringing and not connecting , any ideas?

ok thanks all, think I will get some one in.

Thanks, is that a Messy Job?

I have a Baxi 105e and water keeps appearing in the area near the pump and circuit board. I have traced it and the water is puddling in the tray just under the furnace shown in the pic, and eventually leaks from the tray. Could anyone tell me what is causing the water build up please.

I need to source a breather membraine for walls. Im converting my garage using the Celotex "garage conversion" guide and I have to fit a breather membrane against the single skin brick before the celotex goes on. I have contacted Celotex and they say use Tyvek House wrap but thats only available...

When using Fireline Plasterboard what is the recommended method to join/seal one board to the next, just regular jointing compound? or something special. I'm making stud walls and one side has to use fireline board. Ta

I suppose I could retro fit a cavity tray if the BCO insists right?

its internal yes, the garage roof is only a few brick higher mind, p.s the reason Im putting in the opening is because its a garage conversion im doing. The BCO have accepted the drawings unconditionally and there is no mention whatsoever of a CT

The garage is attached and is single story flat roof so yes there is exposed masonary about 5 bricks up from the lintel

okeykokey that very usefull information. If I dont install one will the BCO inspector kick off?? i.e. is it absolutly essential. FYI Its only a 1200mm lintel, and the cavity is insulated with those polystyrene balls ( which will all fall out when I open the cavity.....cant wait)

Thanks Nose, forgive me for being thick but I didnt understand a word of that, can I just put the lintel in without worying about any of that?

Putting a lintel in tomorrow. Creating a doorway from my hall into the attached garage. The lintel says "DPC Required" . The drawing from my architect doesnt specify one. Do I need a DPC and if so where does this go.. under the lintel ? Ta

Nothing above just more wall. Thanks though that's very helpful

Thanks Nose, Im not sure what "self arching means" but if but if its nothing for me to worry about then who cares. Whilst im on the subject I plan to put this lintel in myself. my plan is this: I have 800mm doorwar to put in, its a cavity wall brick inner and out. Stick a strong boy in 1...

Thanks I will use one then, wasn't sure if the weight of bricks vs blocks could be a factor.

I need to install a lintel for a new door opening. The opening is only 800mm wide. Its a cavity wall with internal and external brick (no block-work) with 50mm cavity. The drawing says use a Keystone S/L-50 lintel. When I have had a look those lintels are suitable for external brick and internal...

Ok so drain the system by turning the pressure release valve (bucket or 2) Pump up the EV to .8 Clean the system and add inhibitor repressurize and hope for the best right?

Right then, the Water is venting from the 3 bar PRV. I have tested the EV by pressing the tip in the valve, only air comes out no water. The pressure is at about 0.5 bar. What procedure should i use totop it up, just use a car pump? do I need to drain the entire system of water first? please help