Search results

14 posts in and not a troll in sight!! they should just be exterminated !

why the op has only said it works ok. first thing you need checking OP is the inlet pressure I:E what actually comes in from the main. the u guage should be on the meter, then turn the hob on, check you still have 21mbar, then check the boiler again you should still have 21 mbar at the meter...

why? its quite common round here!

yes the box can, but the bracket attached to it can't as the pipework passes through it. the meter would have to be removed to get it in place.

they aren't, the plu........hampton one is set up as a seperate site! not what i wanted! i just want my own site optimised to get the soton traffic! too simple i suppose!

sorted that out so the .co.uk forwards to .com now don't know how long thats been wrong :oops: :oops:

interesting! had not looked at .co.uk which should go direct to .com will have a go at that first as you see i need help...... :lol: thanks

thanks my own site is gasregd.com and .co.uk had been on page 1 of google for sometime but has slipped badly. the new one set up by the muppets plumberservicessouthampton.co.uk i'm a gasman predominately hence the id on here and i also do electrics, plumbing and solar hot water.

thanks will have a look. the real issue is the SEO on my own site is crap, employed a company to do the work, 3 weeks and all they have managed is a 2 page website with links to my own!! and their effort isn't working either no traffic through it except me and a customer who has looked at it!

how? does he have a crystal ball?

no £47.00 is about right but they don't pay copper price its just a tank price at my local yard getting around £42 a tank

only thinking about it!! :lol: :lol: got any better ideas? or is your comment the limit of your input? :lol:

doesn't matter as most yards give a price for clean and a lower price for dirty (foam covered) tanks the cooker etc will get you pence rather than pounds but still worth taking if your going.

if you have brought the right thing you will have a 3 part set a base 15mm OD with a 8mm ID approx 10mm in length, a 8mm olive and then a disk 15x8mm of about 4mm length fit the valve nut over the pipe,add the small disk, add the olive and finally the larger base which will stop at the end of...

welcome to the forum, well it doesn't seem like a year ago that i posted this but it is, how time flies, funny that i was only talking with a customer today on the very subject. I am now thinking along the lines of submitting the application again WITHOUT a section 106 agreement, letting them...

so is there a way of viewing my competitors metatags? reason i want to is to see what they are using to get above me on google etc.

you say it only happens when all the rads are in use, this would concur with gordons dianosis as hot water expands and the expansion will increase with more volume of water heated.thus a partial deflation of the expansion vessel can cope with smaller volume but not the larger volume of heated...

its a heat only boiler (a good one, fitted loads) 2 pipes out of top, gas inlet underneath, it should be connected to the radiators and hot water cylinder coil via a mid position valve or 2 zone valves

standard practice is to fit between the rafters, then a 2nd layer over them

very unlikely on a bbu system, the installer wouldn't have bothered as there is usually a drain on the front of the boiler heat exchanger on 401's and 552's turn off the header tank feed add the inhibitor to the loft tank and then drain enough from a low point to get it into system then turn...