Search results

I was in sccrewfix today and purchased the half inch connector and was wa y too big. Does anyone know where I can get a 12mm to 15 connector or even a piece of 12mm pipe?

Good point. I'll leave the pva. I have some dulux sheen white anti mould paint which has an in built primer.. do you think I should use this? Then after a couple of days paint on the dulux bathromm paint?

I am currently refurbing my bathroom. I have one wall which was in bad condition so I removed all the lime plaster and wooden slats to enable me to construct frames for the wall hung basin and toilet. All the other walls are sound and have been plastered in the last 10 years. Due to its...

Googleyhead! your an absolute star, Thankyou, thats exaactly what I need! Buckets no more for the partner.. phew... will take her away until monday when the shops are open. Thankyou so much, not much to you, but you really have relieved a lot of stress. Thankyou so much. Franc

ok, I understand what you are saying, I'm not trying to fit a valve, its just that I had one that reduced 15mm to 12mm and fitted, so thats why I know 12mm would fit... but unfortunately I have a male connector to fit onto to. (the braided hose from the cistern) I suppose a piece of 12mm copper...

I added a 12mm nut and it fitted, so assume its 12mm as 10mm was far too small and 15mm far too big. Its a plastic incased system, but I can see a lever isolation valve inside which can be acessed through a 2cm x 2cm viewing square. Any ideas..

Hi Guys, I'm having a nightmare trying to fing a fitting for a toilet cistern I purchased from ebay. It was imported from China. The toilet cistern has a built in braided hose and has a male 12mm connector on the end! I have searched, but found nothing that would attach.. I have a 12mm to...

Yes. Just measured the flow from the kitchen tap which is located 1.5 meters above the boiler and 5 meters horizontally away. Hot water = 2 litres in 20 seconds Cold water = 2 litres in 16 seconds The bathroom is another 3 meters up above the kitchen. I purchased 2 x bristan lever...

I already have a combi boiler. The cold water tank is being fitted high up in the bathroom. The tank is fed by the cold water main and then an electric pump is built into the shower unit. Please see the mira elite st on the mira site. Thanks for the answer regarding the taps.. its so difficult...

Interesting answer.. may I suggest you re-read my post "pumped electric shower" Its the Mira elite st, which is fed by its own tank, it has nothing to do with the combi as the tank is cold mains fed. Does a mixer tap restrict flow compared to 2 seperate taps on a bath?

1 bathroom only. Anybody know the answer to my original question regarding mixer tap?

Hi, I'm currently rennovating my bathroom in the loft. The hot tap at the moment takes a good 10mins to fill the bath. This is currently an old mixer tap. The pipework is 15mm, with standard iso valves which I am replacing with full bore ones. As I am also building a structure to hold...

perfect, just tried it and hay presto, there off! Thanks a million John!

Hi, I have spent half an hour trying to figure out how to remove the top of these taps to replace the washer.. any advice would be greatly appreciated. photo attached, Thankyou so much, franc [net]

taps

any advice would be greatly appreciated..