Search results

Nice post ban..... like your pics Ok, i'll take some pics and then post..... In short the meter, the main supply and what seems to me to be a main switch are all located on the board. The configuration is as follows: Main wire into - Main fuse - connected to meter - tails out of meter...

Thanks for the help. i decided to contact central networks, who obliged with my concerns and sent an engineer around to look if the installation was safe. They came out within an hour and the chap said that it was safe, despite the fact that he thought that the meter had been moved..... he...

Hi all, I have recently bought a house to modernise and rent out. It seems that the previous person may have moved the main incomer, the reason i say that, is because the board that the henley block is on is slightly over an existing window, i wouldn't think that that would be allowed. I...

Hi, i hope someone can help. Well after deciding on my pump which can be found here http://www.gardensite.co.uk/Henri_Studio_Feature_Pumps.htm i am now confused. Can anyone tell me where the flow regulator is on this pump. I have put the pump into a bucket of water tonight outside and...

Water Pump

Thanks for the quick reply. So, no bonding agent or anything like that, just simply put the masonry paint on neat straight onto the wall.

Hope someone can help me. Can you advise what paint and how best to apply it to a large wall that has been rendered using red sand, cement and lime. The finish is good, but now i need advice on what paint and whether i need to put a base pva on it first. Any suggestions are welcome Andemz

Hi, Hope someone can help me. Can you advise what paint and how best to apply it to a large wall that has been rendered using red sand, cement and lime. The finish is good, but now i need advise on what paint and whether i need to put a base pva on it first. Any suggestions are welcome...

Hi all, Just wondering if anybody could help me. i have purchased a fountain which is in 3 tiers, plus the bottom stand totalling a height of about 6ft 2". the stand which the tiers sit on has a section cut out where obviously the pump fits in. The stand will sit in a circular brick...

Hope you can help. My father, in haste has gone and drilled all of the handles for the doors for his kitchen cupboards on the same side. The doors cost £500, they are light oak from B&Q. Is it possible to fill the holes in with some form of light oak veneer filler. Please advise, if you...

Hope you can help. My father, in haste has gone and drilled all of the handles for the doors for his kitchen cupboards on the same side. The doors cost £500, they are light oak from B&Q. Is it possible to fill the holes in with some form of light oak veneer filler. Please advise, if you...

cheers

I think there is a product that allows you to join two pieces of laminate work surface together. We have a long run in our kitchen and 2 pieces of laminate work surface will need to be joined together. I think I remember a product that is countersunk underneath the work surface and then...

Dear forum members, We have recently had a stop tap fitted outside by the water board, we have since fitted a new rising main inside the house, however whenever any taps are turned on in any part of the house, there has now developed a rushing/gushing sound which is very loud. Can anybody...

40 year old stop tap, which is leaking through the spindle, how can we get over this problem, as there is no stop tap outside, so we are unable to isolate the water. We have been advised to take the nut off on the spindle and put some PTF tape but the nut is solid and it cannot be moved. Any...

I'm with you, basically both the wires going to and from the FCU (i.e the ring circuit) remain on the supply side of the SFCU and the socket below the work surface, whether this be switched or unswitched is connected to the load terminal on the SWFCU.