Search results

Thanks, gas "shouldn't" be a problem as we are on a bulk tank with a high pressure regulator and a high pressure underground feed pipe and then the low pressure regulator is installed at the annex itself.

Hi, It's all happening at once. Let property has Baxi back boiler on LPG. It has provided stirling service and is still going strong. HOWEVER the property only has an EPC 'F' so cannot now be legally rented out. It needs to be an 'E' at least. Apart from digging up the solid floors and...

Thanks.

I need to tee into a rigid 28mm pipe. I can obviously cut out sufficient pipe and would be able to get one end of the tee into place but not the other. So...how would the pros do it...if it can be done ?? Thanks andytw

Looks like your flow switch is leaking. I replaced the poor gaskets with "14MM ID X 4MM METRIC NITRILE 70 RUBBER O-RING" from eBay.

Aha...no experience with bottles..always had a tank

8199V 8199V in my case

Off topic slightly. Have had LPG for heating our annex for many years and were 'locked in' to companies with tank swaps required to change companies. You no doubt have a good 2 year contract, but if you do nothing prices will creep up, bit like insurance. Whilst not available on the 'Go Compare'...

Thanks, washing machine is next to sink. Device is going in sink cupboard.

Just about to fit one of these to reduce some noise when a machine is going through it's motions. Water pressure is, I believe, quite high. Is it just fit and forget or do I need to fiddle with the pressure for best results ? Thanks

I always replace the schraeder valve when doing this. Screws into the valve stem. Few pence from Halfords.

I can understand. We have a Stanley and had difficulty finding an engineer to do a service when the previous one stopped due to ill health. Current engineer is very good though. Bit of a long shot but what part of the UK are you in, he might travel within reason ? We are in Somerset Might be...

Hi I am not a heating engineer so others might jump in with better advice, I was just giving my experience. My boiler is a Baxi Bermuda 552. There is a manual for mine at http://interpart.partsarena.eu/ I have just checked. Another here...

We have one of these in a let property which ran for years without problem then started a banging and popping. I wouldn't have called it kettling but you might. Long story short, problem was eventually found to be the plastic spreader insider the entrance to the heat exchanger. It is there to...

For a slow leak it's probably worth going around each radiator and tighten the bleed valve and it's fitting and the opposite end blanking plug. Then the valve nuts and most importantly the valve spindle nuts. All of these can leak but the water can evaporate before you see it.

Just posted on a similar thread, my neighbours Grant boiler was losing water from the PRV. I checked the expansion vessel and changed the PRV. Same problem, so reluctantly swapped the expansion vessel then found the flexi hose on the expansion vessel was completely blocked so the expansion...

While checking pressure vessel it would be worthwhile checking any hose that connects it to the boiler is not blocked. I had a similar problem with neighbour's boiler. Changed expansion vessel and PRV to no avail, but found the flexi hose was clogged solid. New hose was required (and system...

Looking at the overflow pipe in the middle I think it is just over-filling rather then an issue with a leaky flush valve.