Search results

  1. D

    Tiling a replacement bathroom

    When tiling a replacement bathroom do you fit the bath in against the wall and then tile or do you tile the wall so that they are below where the top of the bath will be before you put the bath in or doesn't it matter?
  2. D

    Expansion Vessel

    Many thanks for the replies, they answered my concern.
  3. D

    consumer unit /shower connection

    I have an electric shower which is directly connected to the consumer unit. I was thinking about having another electric shower connected by an electrician, can that be taken off the same position on the consumer unit as my present shower as I notice the other positions on the consumer unit are...
  4. D

    Expansion Vessel

    For my ch I have just put in an altec 18lt vessel kit with the air schraeder valve pointing up as it assembly says, but what I don't understand is how the air in the lower half of the expansion vessel which is connected to the ch water side is removed as you cannot bleed it, or maybe it doesn't...
  5. D

    Expansion Vessel 18 litre Altecnic Robokit

    1. When connecting the expansion vessel into the ch system does it get warm/hot and if so is it then advisable to connect it in a way to prevent/reduce it warming up? 2. Also I have checked the air pressure on the expansion vessel air valve and it reads 2.0 bar on my car pump check but spec...
  6. D

    Expansion Vessel Altecnic Assembly

    Very many thanks for the reply, I will then put the air valve on the top side and will be able to get at it. Dugit
  7. D

    Expansion Vessel Altecnic Assembly

    I have just bought an Altecnic Robokit for a sealed central heating system and I cannot be sure from the information they supplied with regard to which way the expansion vessel should or may be must be assembled ie with the Schraeder air valve on the top side or underneath or may be either way.
  8. D

    Central Heating will not switch off

    I have never bothered about the frost Stat which I find is situated on outside garage wall and with a Honeywell l641B on boiler pumped return pipe. Is problem caused by colder weather?
  9. D

    Central Heating will not switch off

    Yes Gloworm Ultimate 80ff
  10. D

    Central Heating will not switch off

    My central heating will not switch off although the heating thermostat and programmer are switched to off ie pump/heating carries on,just started today. If I then switch off the mains and switch on again then the pump will finally stop. When I start the heating again for a short while and then...
Back
Top