Search results

I know the 4x2 is probably best. But I'm thinking of speed it's a rental accommodation and by boss is pestering my for how long the job will take

Thanks but if I used the riser kit. Would you spread the weight of the legs with some 4/1 timber under the shower legs?

Can you put them on a plythn and sand and cement if they have holes in for threaded bar like this

it's for a 760 shower tray in an l shaped enclosure up against 2 walls

This type

Are the riser kits for shower trays with the threaded bar that screws in to the tray any good?

I'll have a site search

Is working for the councils as a plumber good? There is a few perks big holidays sick pay etc

It's honey cone but 10mm

End caps for the top. But I need it to be decent where it sits on the bath

The ends look like this on both sides. Would probably have to cut the bottom of it off to get a decent edge to fit in the bath.

Has anyone used the 10mm plastic paneling?

It's sv92467 ideal standard. But I think it's been discontinued

It would fit in the the ideal standard carrier?

Hi does anyone know if you can still get this flush valve? I know it's ideal standard thanks. I'm hoping to get the same.one so it with twist out of the Carrier. Otherwise I will have to take the toilet out. Thanks.

Thanks yes I'm frightened of disturbing in the wall as it all tiled in etc. Thanks

See attached

I have a leak on a bar shower mixer valve. To unscrew and replace the washer do I need to hold back on the 3/4 thread somehow?

Anyone fit filling loop Isos. For isolation and dcv on outside taps?

The pump is working but it could of got lazy? It's a grundfos 15/60. The 3 port valve is new.