Search results

Leak out of the slotted on/off bit?

Are iso valves really that bad? If fitted on a drop to one radiator. As the internal bore of the rad valve is tiny.

Pipe rad up and use push fit or compression as last fitting on to existing?

On the drops the water should stop enough when drained down to solder?

It's an Splan system maybe Splan plus with the central heating zones.

Thank you. It does have an auto air vent

The rads are piped from drops. So thought may not effect the underfloor heating circuit?

I'm draining to swap a couple of rads downstairs.

Is there anything different I need to do when draining a central heating system that has underfloor heating on one side downstairs? Also for refilling thanks

Thanks would you seal between the sockets with anything?

Thanks so no to confirm you wouldn't try and cut a tile for between these two sockets?

Wouldn't be able to cut a bit to go in-between as it's so small. Would you usually just silicone the gap between?

How would you tile a kitchen with sockets like that, that are so close together? Thanks

If you mount pipework on the surface of a plasterboard wall. Would it still be possible to use angled rad valves. Copper pipe run horizontal then and elbow straight in to the angled rad valve. Is there another space for the copper pipe before the fitting?

Thanks, what's the best way of setting them up to hang them? Bottom bracket first then place rad. on. Then mark top brackets?

What are the brackets like? Hooks?

Are colum radiators easy to hang. How are they usually bracketed?

Thanks yes was a long one.

Is it ok to put hep2o street elbows in to compression fittings. With a copper olive. Thanks

If tiling a kitchen of the worktop. Do you usually tile straight on to it. Or put a spacer between it. Thanks