Search results

Thanks. Good shout about the mdf.

Thanks noseall.

Was beginning to wonder if it would be easier to get rid of the old plaster board. Thanks

Hello, Just after some guidance on insulating upstairs bay window. Have some mould growth so needs sorting. Cut back some plaster board and it had some very old insulation in. Am I best filling the void with new loose insulation and then laying some insulated plaster board over the old...

Hello, Just after some guidance on insulating upstairs bay window. Have some mould growth so needs sorting. Cut back some plaster board and it had some very old insulation in. Am I best filling the void with new loose insulation and then laying some insulated plaster board over the old...

It’s more than 2 mm. Maybe 3 or 4. I will try it again and get a picture.

Yes you did. Doesn’t look possible for me. No amount of levering is going to clear the door from the frame. Even managed to pull the bottom track out and still wasn’t enough clearance. Might help if I take the glass out of the door. Job for another day or year At least I know no one can...

So finally got round to try and replace the rollers on the door. Covers are off, anti lift blocks removed. Still impossible to lift out the door. Anyone know how the hell you supposed to get the door out of the frame?

Great advice. Thankyou

Thanks Crank. Sounds worse than I feared. If it’s that difficult to get out then I presume it’s difficult to also get back in? Where would I get the hardware required for the runners. Any ideas?

Hello, I have the attached sliding doors. Don’t know the make. Looks like the rollers have failed as jamming up on closing. Before I set too taking all the covers off does anyone know if there is an easy way to get to the rollers? Thanks

Thanks SFK. You are correct about yellow for warm and white for cold. Managed to get a 24 volt dc power supply today. Wired red into positive and but yellow and white into negative. Works a treat. With a nice light output and colour.

The output wires are crimped to 3 wires of the led strip light of the light fitting.

Hello, Got an LED ceiling light where the driver has failed. 3 output wires coming from driver. See pic. Light used to dim and change between warm white and ice white via remote control. Not bothered about any of this now. Just want the light to be on and at one colour. Will I be able to use...

Hello, Got a LED ceiling light where the driver has failed. Checked the output voltage and the driver has definitely failed. 3 output wires coming from driver. See pic. Light used to dim and change between warm white and ice white via remote control. Not bothered about any of this now. Just want...

Thanks. I might give it a try. Good advice.

Before I went ahead and purchased a new driver I thought it best to check the old one. I get around 86 volts dc output from the driver. The LED’s however are flashing. Would this indicate the LED’s are at fault? I don’t have a dv power supply that puts out 80 volts to test the LED’s.

Result. Thanks very much. Couldn’t seem to find one myself.

Hello can anyone let me know where I can get a replacement driver for the attached please? It is from a 24 watt Sylvania Led ceiling light. Can’t seem to find the same output ratings

Thanks for responding Not really sure what you mean Crystalclear, could you further explain? I want to sort the problem out because it may be causing damp although the DPC seems to be intact.