Search results

Google is your friend http://www.calmagltd.com/calclear

Even if that is the case for all (and i am not sure it is), it still would have been cheaper than the £600 he has paid without having the problem solved

Why not just buy some glass that's already frosted?

Or report him to trading standards for being a rip off merchant, get two or three more people in to give you quotes and diagnose the fault, sounds like you have been done good and proper. And as for those websites, avoid at all costs, rated by who exactly? Probably his mates down the pub...

Top of the page if you search for Patio Spacers http://www.gapfast.com/

Yes almost exactly the same, and the same needle bouncing around as well, what speed setting is the pump on? If it's a three speed pump try turning it down to 1 or 2 and whilst running open the bleed screw on the pump a few times. Like i said i drained mine down and started again.

It's not water your after, it's air, last time i did mine when i replaced the heat exchanger, it was so bad i drained down and refilled and bled again, only way i could get the air out, might be me but i have read that the 28CDI can be a swine to get the air out off, i don't know if yours is the...

If its anything like my 28CDI then probably air in the system causing the noises, you would be suprised how much noise this can make, mine is an absolute bar steward if completely drained down, have you bled the pump?

Why don't you send the pic to Pegler http://www.pegler.co.uk/en/ContactUs/ContactUs

Thanks sorted it

Hi All, I have an Airflow Icon 30 fan with timer module for my bathroom, the module has the terminals N L & T on it, i am assuming that N = Neutral, L = Permanent Live and T = Switch live, in that case the attached should be wired i think N goes to A L goes to C and T goes to B is that...

Assuming the tiles are 12mm thick, each one weighs in at 7.2Kg, per Sq Mtr that is 30Kg, you need to add adhesive and grout to the calculation at approx 4Kg per Sq Mtr. Plasterboard can take 32Kg/Sq Mtr unskimmed, so i would suggest VERY borderline. If tiles are 10mm thick then 25Kg per...

Close the borders we are full!!!

Turns out it was not the cartridge, and showerdoc could not identify it, bought from Screwfix about 7 years ago and they were about as helpful as boil, see this post for the actual problem and resolution http://www.diynot.com/forums/plumbing/worcester-28cdi-hot-water-problems.299152/#2191222

Now sorted, changed the plate exchanger and shower is now hot, and boiler does not switch on and off

Take them all back, you wouldn't want to have that 2-3 mtrs fail now would you?

Hi Papereyes, That works out at about 21KG per Sq Mtr for the tiles you need to add about 4KG for adhesive and grout, so you have no issues The below details the weights for different substrates, Wall Substrates Maximum Weight of Tiling per m² Gypsum Plaster 20Kg/m² Gypsum...

So anybody got an opinion on the temps?