Search results

Thanks all. Perhaps I will go back to screwfix and purchase bulb 92205 which is Halo lights LED bulb then.....?? ElectronicsUK - Can you advise on my other post posted same time as this one :o)

Bulb: from ebay, no +ve -ve identification on bulb. Driver: Halolite constant voltage driver from Screwfix.

I installed one 12v LED lamp (purchased from Ebay) into a recessed MR16 fitting and used a Halolite constant voltage LED driver to power it. It is just going to be used as a night light in the kids room. However, I installed the lamp and it worked fine, I came back 20mins later to check it...

I have 3 LED plinth lights left over from my kitchen install and have put them in some decking outside - I now have no driver for these 3 remaining LED's. I have a 12v Constant voltage driver I could use for these or a standard 60va 12v halogen spot driver/trany - which is best, if any!!

So in a kitchen/special location notifiable, but anywhere else OK?

So as long as you use preassembled CE marked recessed lighting they can be installed any room with no regs certs required??

Can you install recessed SELV lighting into your home in a non special location without a minor works cert or building regs implications? also Can you install SELV recessed lighting into your bathroom without a minor works cert or building regs implications if you use CE marked light...

Thanks guys, I lowered/cut into the concrete floor by an inch and fitted a hardwood sill and new thershold ;o)

Hi there, I'm just fitting a hardwood door sill in place of a ceramic tiled step just beneth my front door. I have removed the tiles and cut into the concrete floor about 20mm in order to get the sill underneith the door jambs. Do I need to place a piece of DPC between the concrete and door...

I have put down engineered real wood floor in the hallway and i am having a nightmare where it arrives at the front door. My new front door arrives on Saturday and i need to get the threshold sorted before then. The problem is that the wood floor is a good 20mm higher than the concrete that...

Anyone agree that standard 1.5mm twin and earth cable would do the job? Just trim back the earth conductor?

105va trany's 2 cable runs from each trany (secondry) max 3m cable run to 50w bulbs

Twin and earth and tape up/snip off the earth? Or would you use a two core flex? I've got loads of 1.5mm twin and earth you see :o)

Secondry.....

Can anyone advise on the correct cable for low voltage lighting (12v). I have used in the past 2.5mm 2 core flex (which I had a big roll given to me but has now run out) but no one seems to sell this. The local elec suppliers say just use .75 flex or a 1.5mm Twin and earth but these seem...

thanks, very much appreiciated.

Thanks jamie, would you or anyone else have a link? Searched the web but not sure of the terminology so makes if difficult.....

Can anyone recommend a suitable product that will solve my problem? Basicly there is an outside toilet that will be removed and a washing machine will be put in it's place. Is there some form of 'waste pipe end cap' that will convert the toilet waste pipe into a small 1.5" size pipe suitable to...

Diaphram or entire valve? R U Confident it's not just a blockage, yours hoping, jonnyd.....

I have a Jaguar Combi boiler that produces no DHW. CH works fine. HOWEVER, if I open all hot taps in the house (3 of them) then the boiler comes on and hot water starts to come through, but any single hot tap on it's own will not allow the boiler to recognise there has abeen a call for DHW...