Search results

Done a bit more playing.. If I blow in the back of inlet I can't blow suggesting the valve is OK or not?, so leads me to think the waste hose might be routed incorrectly? I had to extend it so currently it drops to the floor runs up into the sink cabinet, looping it up above the point it...

Hi, Put in a new (graded) washing machine yesterday. fagor fwm714it It has been sitting in position with the cold feed plumbed for a while. Yesterday I realised I was getting funny tasting water so put a double check valve on the supply before it got to the appliance tap. This cured the...

Thanks for that, that was my very first question. I can live with that then. :)

yep feet fully extended gets me to within 30mm of the top. So even if I had gone for 870mm standard hight still 10mm short..

It says 590mm at bottom and 596 at top. Yeah the height of 170mm is to where the plinth return stops. I've got that but the unit itself is only 660mm as opposed to the 818mm those measurements say. It also shows it going into a hole that is 820mm tall behind it, which is far lower than the...

There is an obvious area that is plinth height and stepped back from the front that is the same level as height as the bottom of the carcass next to it. I'm staring to hate these integrated ones. Problem is we bought this as a graded item and there is no manual with it, the instruction book...

No I've not cut any plinths yet, making sure I have no leaks or issues before I finish that job. There's no way it would fit in a carcass, it's 595mm wide so with an 18mm carcass either side would not fit. The bottom of where the plinth appears to sit is the same height as the carcass next...

Should all these models touch the worktop? We've purchased a Fagor WM714iT, and it gets no where near touching the worktop. You can see the dimensions in the link below and it says it is 820mm high. The feet only provide another 20mm or so of upwards lift so currently it is sitting about 70...

I'd already sealed the cut out using silicone but if I start making the cut out bigger I'll need to do that again I know. I guess they will be poor but they are cheap and the warranty is 2 years so I decided I'll take my chances. Wasn't going to use silicone incase it does fail but the...

Hi, I have a CDA HVG720 to fit. I've had the worktop cut out a by a local fitter and confirmed the dimensions of the cut out are to spec. But when I drop the hob it it's not sitting flush to the worktop in all corners. There appears to be a secondary lip which I guess is supposed...

Oh and you won't actually see that they have been re-drilled either as the taps will still cover the original holes

In hindsight yes I should have recessed the bath more at the other end. The width of the room is ever so slightly shy of a 1400mm bath which is the reason I had to recess it in the first place. I probably should have just gone with a 1300mm bath but was keen to get maximum bath I could...