Search results

hi - i have a riello G2S burner on my boiler. i think it ran out of oil - it was very low & wouldn't start so assumed out of oil. refilled & bled without pump running - the pump but still wouldn't fire. heres whats happening: 1) motor runs for about 20sec then system locks out. 2)...

appreciating your points - from a safety point of view i'm a bit "iffy" myself about the whole thing but to be honest i was tempted - i'm retired mechanic with some health issues that prevent me from "lying under them" - i 've the option of a free standing "scissor lift" but vehicle access...

thanks for your reply & no, not reinforced. the guy i'm buying the 2 post lift from just says i need a 6" floor - i found the info for "the sunk in support pillars" on the net but nothing regarding the mix used.

hi - my garage concrete floor is only about 3 1/2" thick - i am going to install a mid rise 2 post car lift -that is one that just lifts to 48" due to restricted ceiling height. the floor thickness mentioned above requires me to construct deeper mounting pads for each of the 2 posts - these...

cheers for that - ordered one + 1 roll of insulating tape to get it over the £50 for free shipping - to be honest i'd never heard of a sds drill but i've away from the tools other than servicng the family cars for over 20 yrs.

if the wife reads this i'll be getting all those bits for christmas instead - cheers!!

hi - i need to drill 10 holes 7/8" dia and 4" deep in a concrete floor for the purpose of securing the lifting posts of a new mid-rise car lift. problem is i only have a 1/2" 570W b&d hammer drill & will obviously be useless. can anyone therefore please advise on this as i would buy...