Search results

I've tried the trigger wire monitoring one and it makes no affect, I plan on going back up the ladder this afternoon and checking the switches and connections but I'm not sure what else it could be!

I may try this, if it was on and not correctly configured would that be why it is not working and saying it wants hold off power, even though I have connected & checked that there is actually power there?!

I may have done, I took off the jumper but put it back in what seemed like the right place...? What affect does it have on it if I did?

Do you think I should try switching different wires for different things, like change the strobe and bell wire for hold off and the other way round but still connected as it should at the panel, like use different cores for the connections? Thanks

What do you mean by that? As in a fault in the wire that runs to the bell box from the panel? Regards

Anyone?

You do the rf zone programming on the engineer menu, zones, select the zone and then press rf options. Where it says serial no press that and press * to start programming the zone, then open the tamper on the zone and your done!

Hi, I have installed my CQR Orion bell box on the side of my house and when it comes to powering it up, it only bleeps once and the green led stays on, which I believe is supposed to illustrate no hold off voltage?! I have wired it up on the floor to check that it works and functions and it...

That's great! Thanks!

Thanks everyone for you're replys! To address Scott, is the programmable one the one called trig and something like 1001 or something and is underneath the internal sounder output? If so how is it that it is programmed for bell use? Regards

Hi, it's the Galaxy G2-20 system, for now I've just got the strobe & bell working off of the strobe connection and it seems to work, only problem being that I can't set the strobe on its own for set confirmation without ****ing off the neighbours! Thanks!

Hi, I've just wired up a external sounder to my Honeywell galaxy system, And it seems that the siren trigger output is constantly on! Is there a reason for this? Thanks

Thanks very much, I'll connect it all up tomorrow!

Hi there, thanks for replying My question is what are the connections to the panel, the bit above the connection terminals on the bell were just an accidental copy! Any ideas? thanks

Oops to above my dodgy pasting

Hi there, I have a question about my Bellbox and was recommended to go on this site to find an answer by someone else who has been and got answers! I wish to connect my CQR Sigma bell box to my Honeywell galaxy 2 12 system the connections on the bell appear t be B - black strobe (minus)...