Search results

cheers ch427 i will try that, in fact id try anything, id even chop my left nut off to fix this van.

good point tommy but 25mm is a bit much and i wont be using end pannels only for plynths just the last 1.5 meters where the gap will be too bad. i can get a pack of 2 x 1800mm x 570mm for about £45 which isnt that bad especially when i take the short ones back this is the best solution i can...

it has a throttle cable that goes into a throttle position sensor and the pump is electrical, i am beginning to suspect the throttle pos sensor

another idea would be to start from heighest point and when i get to lowest point take back my short end pannels and get the long ones and cut to size, i could also cut a long end pannel down for the plynths if required your thoughts on this would be apprechiated Rich.

trouble is the plynths are 150mm and if i reduce the legs down to min its 150mm so i would need to cut the legs down too its an old terraced house early 1900`s the floor is out 25mm over 3100mm and yes i levelled laser correctly and double checked by marking wall and checked with spirit...

hi i have bought a b&q kitchen and have built the units up and used one of them lasers on a tripod to mark out base units and theres about 25mm difference from one end to the other so my question is do i start at the lowest point or the heighest???? id have thought the heighest but there would...

:?

what would you suggest rf lighting

that`l do Thankyou

hi i have a marbo consumer unit installed in my property and we are in the process of moving the kitchen and associated wiring but my electrician and i are having trouble locating a marbo mcbo or an rcd also an mcb its as if these never exsisted nobody sells them we bought the original from...

checked all vacum pipes etc had a look round all wires and linked ecu to computer again and all was clear also changed the vacum pump over from my original engine and still no change. time to scratch my head again :? any ideas or suggestions welcome

cheers, im going to give it a full ay tomorrow (weather permitting) fingers crossed :) Rich

also as a trial and error we had all fault codes cleared and checked and this made no difference

hi guys all was well until my timing belt snapped also taking out the cam (snapping it into 3 parts) we couldnt get hold of a topend from any scrappies as nobody would split so we bought a full engine and popped it in all works great eg starting and running etc but it idles at around 2500 to...

we normally change them for new anyway to save messing, any slight fault we just change them (comes out of the boss`s pocket :wink: )

truth is its hard as hell to make it out there, you mention loans etc dont do it, why would you want to get a loan when your not going to be earning a wage thats providing you could get one in the first place. i dont mean to be blunt or negative but its the truth because nobody knows about you...

where abouts in yorkshire are you based?

i had the filling loop leak once but i undid it and re-tightened it and it sorted it, must admit they give me an E R E C T I O N. :lol:

also check on inlet for an isolation valve and check it.