Search results

Thanks mate for your prompt reply. The previous tenants just left and there was no issue before.

Yes, try to switch to Auto or Manual, no lights on . "Has the power supply to the Salus been turned off at the FCU?" How to find this, in the main power switch of home?

Hi All, just urgent question, my house change for new tenant and today we find no light in it500 receiver, already called previous tenant and was told heating works fine. Any indication how to solve the issue? Thanks a million

Thanks for your comment, the pressure drop from 3.2 bar to 2.8 bar when drain the radiator, then it appears error of F75(water shortage), I need to open fill loop valve to turn on boiler. Then just keep the same phenomenon.

When turn on Vaillant ecoTEC plus, bar symbol flashing from time to time, indicate filling pressure outside permitted range(around 3.1bar), when flashing the burner turn on as well. I've tried to drained radiator to lower pressure but doesn't work. Advice are highly appreciated.

Thanks, could you advise any solution?

Pls refer to images as attached.

Hi, I've found many peeling off on my shed flat roof, not sure is made of pitch or not?(get immediate warmer when there is sunshine), alread caused leakage when there is rain. Can someone advise how to settle the issue. Pls refer to images as attached. Thanks in advance! Eric

I am not sure, pls refer to the photo

Hi, I climbed on the loft recently and mistaken stepped on wooden surface instead of beam, and therefore result in some damage, can anyone give professional comment? Thanks in advance!

Hi Mate, I already got new seal and grease in hand, how long need to put grease around the seal,before reinstall back?

Thanks Mate!(I don't know your name) You really help me a lot！

Thanks Mate! I already got O ring seal out and found some wearout on it, shall purchase new one to replace.

Thanks Mate, I am still strugling to get rubber seal out, its on back side of rail......

Not yet, which kind of grease, the seal is on the back of rail, very difficult to take out

Hi, today I removed plate heat exvhanger and washed, but when I assemble plate heat exchanger back, there is always powerful water leak form right part(exchanger), even I think screw is secured, any comment about the reason? Thanks in advance!

Thanks Mate, yes I found them on rail assembly, now another issue, when I assemble plate heat exchanger back, there is always water leak form right part(exchanger), even I think screw is secured, any comment?

Hi, I found the instruction of remove plate heat exchanger says to remove 4 rubber seals, but don't find any, can somebody if I can wash and assemble plate heat exchanger without rubber sea? Thanks in advance!

Thanks Mate!

Thanks Chris, I reckon block in heat exchanger might be the most probable reason, now checking how to replace or flush, really appreciate your professional comment!