Search results

So the engineer came around again today and he spent 2 and half hours without replacing any parts just checking, going back and forth. His biggest complaint was that boiler was operating at dangerous CO2 levels. He did however was able to make central heating work again however for short period...

My boiler has two problems one the central heating doesn't work and second hot water works but sometimes it stops working and the boiler locks out. So I called an engineer out and after checking for few minutes he quoted me with £210 for the part to be replaced (heat exchanger plate) and get the...

The boiler also locks out sometime when using the domestic hot water which I believe is due to blocked heat exchanger plate. Anyways I think I will be calling an engineer tomorrow depending on how much he wants to charge I will see if I should get it repaired or replace the boiler. If I were...

I have been reading around here and I came across few suggesting it could be the safety thermostat or the one in my room. However seeing as though the situation is not getting any better I will be calling an engineer but I appreciate your help.

I assure you that not servicing the boiler was complete ignorance on my part and it is only recently I have come to realize that I needed annual servicing. I will be calling an engineer but I was put off by the last one who wanted me to pay more than 500 to repair it. So I wanted an opinion...

The boiler was installed in 2007 and the boiler hasn't had full service since then ( which I know is my fault). However we had an engineer recently look at it few months ago and after spending couple of hours trying fixing the problem he had the nerve to ask for £300 and said that gas valve...

The lights show CH in operation ( side lights flashing and middle light off) however after few tries the boiler locks down and the lights indicate lack of burner ignition. The problem is the boiler fires for 3 to 5 seconds but just doesn't pickup like it does with DHW. So lack of burner ignition...

Hi, I am currently facing some problems with the Biasi M110.32SM/E where the hot water works fine ( the boiler sometimes goes in lock out mode) but the central heating just does not work. I turn on the central heating the boiler recognizes this and fires up but only for two seconds and then the...

Ok guys while searching through the various threads I came across a suggestion where this guy turned off the power supply to the diverter valve after it had locked into CH mode. Then he turned on the hot water keeping the central heating switched off. So the tap water will obviously run cold as...

Hi, I am currently facing some problems with the Biasi M110.32SM/E where the hot water works fine ( the boiler sometimes goes in lock out mode) but the central heating just does not work. I turn on the central heating the boiler recognizes this and fires up but only for two seconds and then the...